DIGISTAT
INSTALLATION
DIGISTAT / DT20RF RECEIVER
MOUNTING THE DIGISTAT
1. Loosen the single screw from the bottom of the
transmitter using a small flat bladed screwdriver.
2. Carefully insert the screwdriver into the slot
located at the back of the digistat near the top
and very gently lever upwards a fraction to release
the tab securing the front of the transmitter to the
back cover.
The the back cover can now be secured to the
wall.
Mounting the Digistat RF room thermostat
3. Replace the front by locating in position and
pushing fully onto the back cover until the tab
engages at the top of the transmitter.
4. Retighten the screw at the bottom of the unit to
fully secure the front to the back cover.
DT20RF PROGRAMMER
INSTRUCTION MANUAL
8 716 115 495a (02.2009)
OPERATING & INSTALLATION
INSTRUCTIONS
23
Positioning the Digistat RF room thermostat
The Digistat is a radio frequency device which is very
flexible for positioning as there is no need for hard
wiring to the appliance. The device should be mount-
ed in a open area, no closer than 30cm from metal
objects, including wall boxes.
Mount the Digistat on a wall which is not subject to
direct sunlight or draughts, preferably on an inside
wall, 1.5 metres above the floor. The Digistat must
also not be directly influenced by radiators or other
appliances giving off heat.
