Bedienungsanleitung Bosch DWB97IM50 (Seite 13 von 16) (Englisch)

746547

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

en Important safety information

supplied. Toxic gases from the chimney or the

extraction shaft are sucked back into the living

space.

■ Adequate incoming air must therefore

always be ensured.

■ An incoming/exhaust air wall box alone will

not ensure compliance with the limit.

Safe operation is possible only when the

partial vacuum in the place where the heat-

producing appliance is installed does not

exceed 4 Pa (0.04 mbar). This can be

achieved when the air needed for combustion

is able to enter through openings that cannot

be sealed, for example in doors, windows,

incoming/exhaust air wall boxes or by other

technical means.

In any case, consult your responsible Master

Chimney Sweep. He is able to assess the

house's entire ventilation setup and will

suggest the suitable ventilation measures to

you.

Unrestricted operation is possible if the vapour

extractor hood is operated exclusively in the

circulating-air mode.

:Warning – Danger of death!

Risk of poisoning from flue gases that are

drawn back in. If installing a ventilation system

in a room with a heat-producing appliance

connected to a chimney/flue, the electricity

supply to the hood must be equipped with a

suitable safety switch.

:Warning – Risk of injury!

■ Components inside the appliance may have

sharp edges. Wear protective gloves.

Risk of injury!

■ The appliance may fall down if it has not

been properly fastened in place. All

fastening components must be fixed firmly

and securely.

Risk of injury!

■ The appliance is heavy. To move the

appliance, 2 people are required. Use only

suitable tools and equipment.

Risk of injury!

■ Changes to the electrical or mechanical

assembly are dangerous and may lead to

malfunctions. Do not make any changes to

the electrical or mechanical assembly.

:Warning – Risk of electric shock!

■ Components inside the appliance may have

sharp edges. These may damage the

connecting cable. Do not kink or pinch the

connecting cable during installation.

Risk of electric shock!

■ It must always be possible to disconnect

the appliance from the power supply. The

appliance must only be connected to a

protective contact socket that has been

correctly installed. If the plug can no longer

be reached after installation, an energy-

isolating device in the phases must be

provided in the permanent electrical

installation in accordance with the

installation regulations. The permanent

electrical installation must only be wired by

a professional electrician. We recommend

installing a residual-current circuit breaker

(RCCB) in the appliance's power supply

circuit.

:Warning – Risk of electric shock!

Incorrect repairs are dangerous. Repairs may

only be carried out and damaged power

cables replaced by one of our trained after-

sales technicians. If the appliance is defective,

unplug the appliance from the mains or switch

off the circuit breaker in the fuse box. Contact

the after-sales service.

:Warning – Danger of suffocation!

Packaging material is dangerous to children.

Never allow children to play with packaging

material.

General information en

KGeneral information

Gener al i nf or mat i on

Checking the wall

■ The wall must be level, vertical and adequately load-

bearing.

■ The depth of the bore holes must be the same

length as the screws. The wall plugs must have a

secure grip.

■ The enclosed screws and wall plugs are suitable for

solid brickwork. Suitable fasteners must be used for

other structures (e.g. plasterboard, porous concrete,

poroton bricks).

■ The maximum weight of the extractor hood is 40 kg.

Electrical connection

:Warning – Risk of electric shock!

Components inside the appliance may have sharp

edges. These may damage the connecting cable. Do

not kink or pinch the connecting cable during

installation.

The required connection information can be found on

the rating plate on the top of the appliance.

Length of the cable: approx. 1.30 m

This appliance complies with the EC interference

suppression regulations.

:Warning – Risk of electric shock!

It must always be possible to disconnect the appliance

from the power supply. The appliance must only be

connected to a protective contact socket that has been

correctly installed. If the plug can no longer be reached

after installation, an energy-isolating device in the

phases must be provided in the permanent electrical

installation in accordance with the installation

regulations. The permanent electrical installation must

only be wired by a professional electrician. We

recommend installing a residual-current circuit breaker

(RCCB) in the appliance's power supply circuit.

5Installation

I nst al l at i on

Preparing the installation

Caution!

Ensure that there are no electric wires, gas or water

pipes in the area where holes are to be made.

Caution!

Holes must be drilled differently depending on how the

appliance is designed. Before installing the extractor

hood, take note of its design.

1. Mark a vertical centre line on the wall from the

ceiling to the lower edge of the extractor hood.

2. Mark positions for the screws and the contour of the

attachment area.

3. Drill 8mm Ø holes to a depth of 80mm and press

the wall plugs flush with the wall. ¨

5. Screw in 2 securing screws with washers to

approx.5mm. ª





[





 

! !







Bosch DWB97IM50 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bosch DWB97IM50

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info