Bedienungsanleitung Bosch DWK67EM60 (Seite 11 von 16) (Englisch)

746532

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Installation instructions en

▶

To ensure correct installation, you must use a mater-

ial which is sufficiently stable and suitable for both

the structural conditions and the weight of the appli-

ance.

Changes to the electrical or mechanical assembly are

dangerous and may lead to malfunctions.

▶

Do not make any changes to the electrical or mech-

anical assembly.

The filter cover may swing out.

▶

Open the filter cover slowly.

▶

Take hold of the filter cover after opening until it no

longer swings out.

▶

Close the filter cover slowly.

Risk of injury when opening and closing the hinges.

▶

Keep your hands away from the hinges.

WARNING‒Risk of electric shock!

Sharp-edged components inside the appliance may

damage the connecting cable.

▶

Do not kink or trap the connecting cable.

If the appliance or the power cord is damaged, this is

dangerous.

▶

Never operate a damaged appliance.

▶

Never pull on the power cord to unplug the appli-

ance. Always unplug the appliance at the mains.

▶

If the appliance or the power cord is damaged, im-

mediately unplug the power cord or switch off the

fuse in the fuse box.

▶

Call Customer Service. →Page8

▶

Repairs to the appliance should only be carried out

by trained specialist staff.

Improper repairs are dangerous.

▶

Repairs to the appliance should only be carried out

by trained specialist staff.

▶

Only use genuine spare parts when repairing the

appliance.

▶

If the power cord of this appliance is damaged, it

must be replaced by trained specialist staff.

Improper installation is dangerous.

▶

Connect and operate the appliance only in accord-

ance with the specifications on the rating plate.

▶

Connect the appliance to a power supply with al-

ternating current only via a properly installed socket

with earthing.

▶

The protective conductor system of the domestic

electrical installation must be properly installed.

▶

Never equip the appliance with an external switch-

ing device, e.g. a timer or remote control.

▶

When the appliance is installed, the mains plug of

the power cord must be freely accessible. If free ac-

cess is not possible, an all-pole isolating switch

must be installed in the permanent electrical installa-

tion according to the conditions of Overvoltage Cat-

egory III and according to the installation regula-

tions.

▶

When installing the appliance, check that the power

cable is not trapped or damaged.

13.6 Information on the installation situation

¡ Install this appliance on the kitchen wall.

13.7 Instructions for the exhaust air pipe

The appliance manufacturer does not provide any war-

ranty for faults attributable to the pipeline.

¡ Use a short, straight exhaust air pipe with as large a

pipe diameter as possible.

¡ Long, rough exhaust air pipes, many pipe bends or

small pipe diameters reduce the suction power and

increase the fan noise.

¡ An exhaust air pipe that is made of non-combustible

material.

¡ To prevent condensate from returning, fit the ex-

haust air pipe from the appliance with a 1° gradient.

Round pipes

Use round pipes with an inner diameter of 150mm (re-

commended) or at least 120mm.

Flat ducts

Use flat ducts with an inner cross-section that corres-

ponds to the diameter of the round pipes:

¡ Diameter of 150mm corresponds to ap-

prox.177cm².

¡ Diameter of 120mm corresponds to ap-

prox.113cm².

¡ Use sealing strips for different pipe diameters.

¡ Do not use any flat ducts with sharp bends.

13.8 General information

¡ To optimally detect the cooking vapours, install the

appliance in the middle of the hob.

¡ In order to freely access the appliance for servicing,

select an easy-to-reach installation site.

¡ The surfaces of the appliance are sensitive. Avoid

damaging them during installation.

13.9 Installation

Preparing the appliance

▶

Remove the grease filters.

To avoid causing damage, do not bend the grease

filters.

Checking the wall

Check whether the wall is horizontal and adequately

load-bearing.

The max. weight of the appliance is 25kg.

Drill the hole depth in accordance with the length of

the screws.

Install the appliance with a fixing material which is

sufficiently stable and has been adjusted accord-

ingly for both the structural conditions and the

weight of the appliance.

Check the cut-out area for existing cables of other

appliances.

Preparing the wall

Cover the hob to prevent damage.

Remove the drilling template.

The cardboard drilling template is part of the pack-

aging.

Mark a vertical centre line on the wall from the ceil-

ing to the lower edge of the appliance.

Using the drilling template, measure and mark the

positions of the fastening screws.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch DWK67EM60 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bosch DWK67EM60

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info