Bedienungsanleitung Bosch EasyHedgeCut 12-35 (Seite 18 von 282) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

707788

Zoom out

Zoom in

Vorherige Seite

1/282

Nächste Seite

18 | English

F 016 L81 736 | (23.5.17) Bosch Power Tools

AL 1115 CV

Flashing Battery Charge Indicator

The charging procedure is signalled by a

flashing battery charge indicator.

Continuous Lighting of the Battery Charge

Indicator

Continuous lighting of the battery

charge indicator indicates that the

battery is fully charged or that the

temperature of the battery is not with-

in the allowable charging temperature range, and cannot be

charged for this reason. The battery is charged as soon as the

allowable charging temperature range is reached.

When the battery is not inserted, continuous lighting of the

battery charge indicator indicates that the mains plug is in-

serted in the socket and that the battery charger is ready for

operation.

Charging Advice

With continuous or several repetitive charging cycles without

interruption, the charger can warm up. This is not meaningful

and does not indicate a technical defect of the battery charg-

er.

A significantly reduced working period after charging indi-

cates that the battery is used and must be replaced.

Working Advice

 Hold the garden product away from yourself. Stand in a

secure and stable position.

 When storing the product, do no store it hanging on the

front handle or switch.

Anti Blocking

If the blade stalls on a tough material, the load of the motor in-

creases. The intelligent micro-electronics senses this over-

load condition and repeatedly reverses the motor, in order to

prevent stalling and to cut the material through.

This audible reversing cut action continues for up to 3 s.

After cutting through, the garden product continues in its nor-

mal mode, or in case the overload condition continues the

blades automatically stop in the open position (e. g. in case a

piece of metal fence accidentally blocks the garden product).

Troubleshooting

Problem Possible Cause Corrective Action

Hedgecutter does not

operate

Battery discharged Recharge battery; also see “Battery Charging”

Safety switch not activated correctly see “Mounting and Operation” for correct use

Hedgecutter operates

intermittently

Internal wiring of machine damaged Contact Service Agent

On/Off switch defective Contact Service Agent

Motor reverses repeatedly then stops after 3 s. see “Working Advice” (Anti Blocking)

Motor runs but blades

remain stationary

Internal fault Contact Service Agent

Cutting blade hot Cutting blade blunt Have blade sharpened

Cutting blade has dents Have blade inspected/overhauled

Too much friction, due to lack of lubricant Apply lubricant spray (1 609 200 399)

Blade will not move Battery discharged Recharge battery; also see “Battery Charging”

Machine defective Contact Service Agent

Excessive vibrations/

noise

Machine defective Contact Service Agent

Cutting time per battery

charge too low

Too much friction, due to lack of lubricant Apply lubricant spray

Blade needs cleaning Clean blade

Battery not fully charged Recharge battery; also see “Battery Charging”

OBJ_BUCH-1685-008.book Page 18 Tuesday, May 23, 2017 2:11 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch EasyHedgeCut 12-35 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info