458017
29
Zoom out
Zoom in
Vorherige Seite
1/88
Nächste Seite
6 720 645 347 (2010/09)
Operation | 29
Programming of the holiday program is now
complete. If required, you can adjust the heating
and DHW modes. The following modes are set by
default:
Heating system: operating mode Frost .
Domestic hot water: operating mode Off
1)
or
15 °C
2)
.
DHW circulation pump: operating mode Off.
Thermal disinfection: operating mode Off.
When the holiday program is active, the standard
display shows and, for example, HOLIDAY
UNTIL 30.09.2010.
To cancel the holiday program early:
B Select menu Holiday > Start.
B Press rotary selector and then press
.
The display shows --:--:----.
B Press rotary selector to store the
setting.
5.4 Changing the set room
temperature
5.4.1 Permanently changing the set room
temperature
The following temperatures are stored as the
factory settings for the set room temperature:
Operating mode Comfort : 21 °C
Operating mode Economy : 15 °C
Operating mode Frost : 5 °C
The heating controller controls the heating
system so that actual room temperature is kept
as close as possible to the set room temperature,
subject to the set operating mode (in mode
subject to the active heating program and the
time).
If you wish to permanently alter the set room
temperature, proceed as follows:
B Call up menu Heating > Parameter > Heating
levels.
B Set the temperature for each operating mode
(Æ chapter 6.2.2, page 40).
5.4.2 Changing the set room temperature for a
limited period
B Set the required room temperature with .
While you are changing the set room
temperature, the display shows the required
room temperature.
If the operating mode selector is set to
:
The new temperature applies until the next
switching point.
If the operating mode selector is set to
/ / : The new temperature applies
until the selector position is changed.
If you have set the holiday program
to start on today's date, it will start
immediately. If the date is in the
future, the holiday program will
start at 00:00 h on the set start
date.
It will end at 23:59 h on the set end
date.
1) DHW heating by combi boiler or with
FR 100 via DHW cylinder
2) DHW heating via DHW cylinder (only FR 110)
The controller provides the option of
setting the required room
temperature for the operating mode
concerned.
29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bosch FR 100 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Bosch FR 100

Bosch FR 100 Bedienungsanleitung - Deutsch - 40 seiten

Bosch FR 100 Bedienungsanleitung - Holländisch - 88 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info