458024
36
Zoom out
Zoom in
Vorherige Seite
1/76
Nächste Seite
6 720 645 349 (2010/09)
36 | Adjusting the MAIN MENU
6.4.4 Time program for DHW circulation pump
(only with DHW cylinder)
Menu: Domestic hot water > DHW circ pump
prog
Use this menu if you want to use a time program
for the DHW circulation pump.
The time program is only programmable and
active if Domestic hot water > DHW programme
> Separate programmes is set.
Automatic changeover between DHW
circulation pump On / Off in accordance with
the time program entered.
On: DHW circulation pump starts as per
setting (Æ chapter 6.4.5 on page 37).
Off: The DHW circulation pump is stopped.
Setting options
Up to six switching times per day with two
different operating modes (On / Off).
Optionally the same times or different times
for every day for All days / Mon - Fri / Sat +
Sun.
The shortest switching interval is 15 minutes
(= 1 segment).
Setting switching times and the operating mode
Enter or view days of the week, switching times
and associated operating modes (On / Off), as
described in chapter 6.3 on page 32.
6.4.5 Parameters for DHW
Menu: Domestic hot water > Parameter >
Cylinder temp at heating level Comf.
This menu point is only active if Domestic hot
water > DHW programme > As heating
programme is set (Æ chapter 6.4.1 on page 34).
This is where you set the required DHW
temperature for your DHW cylinder.
Menu: Domestic hot water > Parameter >
Cylinder temp at heating level Eco
This menu point is only active if Domestic hot
water > DHW programme > As heating
programme is set (Æ chapter 6.4.1 on page 34).
This is where you set the required reduced DHW
temperature for your DHW cylinder.
Menu: Domestic hot water > Parameter > DHW
priority
This menu point is only active if Domestic hot
water configuration in the system configuration
has been set to Cyl on IPM ident.3...10
(Æ chapter 8.1.1 on page 43). Use this menu if
your heating is to be left operational during
cylinder heating (e.g. for buildings with limited
insulation and low outdoor temperatures).
Priority: Central heating stops during cylinder
heating. The pump stands still and the mixer is
closed.
Conditional priority: If a mixer is installed,
central heating continues during cylinder
heating ; the pump runs and the mixer
regulates to the required heating
temperature. If no mixer is installed, central
heating will be switched off to prevent rooms
getting too hot. Cylinder heating takes longer
with Conditional priority.
Disable switching points that are
not required by deleting them.
36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bosch FW 100 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Bosch FW 100

Bosch FW 100 Bedienungsanleitung und Installationsanweisung - Deutsch - 76 seiten

Bosch FW 100 Kurzanleitung - Deutsch - 2 seiten

Bosch FW 100 Bedienungsanleitung - Englisch - 40 seiten

Bosch FW 100 Kurzanleitung - Holländisch - 2 seiten

Bosch FW 100 Bedienungsanleitung - Holländisch - 44 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info