458024
59
Zoom out
Zoom in
Vorherige Seite
1/76
Nächste Seite
6 720 645 349 (2010/09)
Troubleshooting | 59
Information displayed
(Æ items 1, 3 and 4 in Fig. 25)
Text Code Cause Remedy (by contractor)
Fault 01
BUS communication fault
10 BUS subscriber FB 100
assigned to IPM no longer
responds.
Check BUS subscriber, BUS
connection and repair circuit
break if necessary.
200 Heating appliance no longer
reporting.
201 Incorrect BUS subscriber
connected.
Identify and replace incorrect
BUS subscriber.
Fault 02
Internal fault
40 Incorrect BUS subscriber
connected.
Identify and replace incorrect
BUS subscriber.
41 Two identical codes entered at
IPM.
Switch system off and correct
coding.
42 DIP switch on IPM in
intermediate position.
50 Thermal disinfection via IPM
failed.
Turn flow temperature
controller on heating appliance
fully clockwise.
100 ISM not responding. Check BUS connection and
repair circuit break if
necessary.
254 Fault message overflow.
Fault 02
Internal fault
Some parameters reset to factory settings
due to EEPROM problem
205 See display text.
1)
Check parameter settings and
readjust as necessary. Identify
and replace faulty controller/
remote control.
Fault 02
Internal fault
FW100/FB100 can no longer control CH
system
255 See display text.
1)
Identify and replace faulty
controller/remote control.
Fault 03
Room temp sensor faulty
20 Room temperature sensor built
into FW 100/FB 100/FB 10 has
suffered a break.
Identify and replace faulty
controller or remote control.
21 Short circuit on room
temperature sensor built into
FW 100/FB 100/FB 10.
Fault 10
System configuration: invalid Remote
control detected or set for non-existent
heating circuit. Check identification.
195 See display text.
1)
Check system layout, check
system configuration, and
modify if necessary.
1) The display text is shown at the BUS subscriber (e.g. remote control) that has identified the fault. The other BUS
subscribers will instead display the code that corresponds to the display text.
59

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bosch FW 100 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Bosch FW 100

Bosch FW 100 Bedienungsanleitung und Installationsanweisung - Deutsch - 76 seiten

Bosch FW 100 Kurzanleitung - Deutsch - 2 seiten

Bosch FW 100 Bedienungsanleitung - Englisch - 40 seiten

Bosch FW 100 Kurzanleitung - Holländisch - 2 seiten

Bosch FW 100 Bedienungsanleitung - Holländisch - 44 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info