458024
64
Zoom out
Zoom in
Vorherige Seite
1/76
Nächste Seite
6 720 645 349 (2010/09)
64 | Troubleshooting
9.2 Troubleshooting without display
Problem Cause Remedy
Required room temperature
not achieved.
Thermostatic valve(s) set too low. Set thermostatic valve(s) higher.
Heating curve set too low. Set "Heating levels" for "Comfort" higher
or arrange for your contractor to correct
the heating curve.
Flow temperature controller on heating
appliance set too low.
Set flow temperature controller higher.
Reduce influence of solar optimisation if
necessary.
Air lock in heating system. Bleed radiators and vent heating system.
Heating lasts too long. "Heating up speed" set too low. Set "Heating up speed", for example, to
"Fast".
Required room temperature
greatly exceeded.
Radiators become too hot. Set thermostatic valve(s) lower.
Set "Heating levels" for "Comfort" lower
or arrange for your contractor to correct
the heating curve.
Installation location of FW 100
unfavourable, e.g. external wall, close to
window, in a draught, ...
Select a better installation location for
FW 100 and ask your heating contractor
to reposition it.
Excessive room temperature
fluctuations.
Temporary influence of external heat on
the room, e.g. through solar radiation,
lighting, TV, fireplace etc.
Arrange for your contractor to increase
"Room influence".
Select a better installation location for
FW 100 and ask your heating contractor
to reposition it.
Temperature rises instead of
falling.
Time incorrectly set. Check time setting.
Room temperature too high
during "Economy" and/or
"Frost" mode.
Building retains a lot of heat. Set an earlier switching time for
"Economy" and/or "Frost".
Incorrect or nocontrol. BUS connection of BUS subscribers
faulty.
Ask your heating contractor to check the
BUS connection against the wiring
diagram and correct it if required.
Controller can only be set to
automatic mode.
Operating mode selector faulty. Have FW 100 replaced by your contractor.
DHW cylinder does not heat
up.
DHW temperature controller on heating
appliance set too low.
Set DHW temperature controller higher.
Reduce influence of solar optimisation if
necessary.
Flow temperature controller on heating
appliance set too low.
Turn flow temperature controller on
heating appliance fully clockwise.
64

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bosch FW 100 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Bosch FW 100

Bosch FW 100 Bedienungsanleitung und Installationsanweisung - Deutsch - 76 seiten

Bosch FW 100 Kurzanleitung - Deutsch - 2 seiten

Bosch FW 100 Bedienungsanleitung - Englisch - 40 seiten

Bosch FW 100 Kurzanleitung - Holländisch - 2 seiten

Bosch FW 100 Bedienungsanleitung - Holländisch - 44 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info