Bedienungsanleitung Bosch GHP 5-14 (Seite 7 von 57) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

544491

Zoom out

Zoom in

Vorherige Seite

1/57

Nächste Seite

English | 7

Bosch Power Tools F 016 L70 892 | (14.10.13)

Maintenance and Service

Maintenance

 Stop, remove plug from the power supply and discon-

nect from water supply.

Note: To ensure long and reliable service, carry out the follow-

ing maintenance regularly.

Regularly check for obvious defects such as loose fixings, and

worn or damaged components.

Check that covers and guards are undamaged and correctly

fitted. Carry out necessary maintenance or repairs before us-

ing.

Pump and motor of this productis is made of durable materi-

als. Nevertheless oil is aging and seals, valves, O-rings, noz-

zles and hose are subject to natural wear and tear. It is recom-

mended, to bring the machine to an authorized Bosch Service

Centre for an oil change and service check every 200 hrs of

operating time.

Fuses blow Fuses incorrectly rated Change to a mains supply higher than the

pressure washer amp consumption

Motor starts but no pressure Nozzle partly blocked Clean nozzle

Motor “sounds” but fails to start Insufficient power supply Check that the voltage of the mains pow-

er supply line is the same as that on the

plate.

Voltage loss due to use of extension cable Check characteristics of extension cable

Appliance not used for a long period of

time

Contact your Bosch Service Centre

Problems with TSS (Total Stop System)

device

Contact your Bosch Service Centre

Pressure pulsating Air in the inlet water supply hose/pump Allow pressure washer to run with open

spray handle and nozzle at low pressure

until regular working pressure is obtained

Inadequate water supply Check that the water supply corresponds

to specifications. The minimum specifica-

tion for the water supply hose is 1/2" or

13 mm diameter

Water filter blocked Clean water filter

Water supply hoses squeezed Straighten out kinked water supply hoses

High pressure hose too long Remove high pressure extension hose.

Retry (extension hose max. 7 m)

Pressure too low, but steady

Note: Several types of accessory will nor-

mally deliver a lower pressure

Nozzle worn Change the nozzle

Start/stop valve worn Activate trigger five times in quick suc-

cession

Motor starts up but with restricted or no

working pressure

No water supply Connect water supply

Water filter clogged up Clean the water filter

Nozzle clogged up Clean nozzle

The pressure washer starts irregularly by

itself

Pump/power gun leaky Contact your Bosch Service Centre

Water leaks from machine Leaking pump A slight water leak is permissible; in case

of excessive leak, contact Service centre.

No detergent taken in Adjustable nozzle on high pressure set-

ting

Set nozzle on “Lo” setting

Detergent too dense Dilute with water

High pressure hose extension being used. Fit original hose.

Deposits or restriction in detergent cir-

cuit

Flush with clean water and eliminate any

restrictions. If the problem persists, con-

tact your Bosch Service Centre.

Problem Possible Cause Corrective Action

OBJ_BUCH-1643-003.book Page 7 Monday, October 14, 2013 1:33 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch GHP 5-14 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info