Bedienungsanleitung Bosch HBC 26D553 (Seite 19 von 28) (Englisch)

110637

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Replacing the cooking compartment bulb

Heat-resistant 25 W, 220/240 V bulbs, E14 bulb sockets and

the seals are available from the after-sales service. Please

specify the E number and FD number of your appliance.

: Risk of burns!

Allow the cooking compartment and cooking compartment light

to cool before changing the bulb.

1. Switch off the fuse in the fuse box or unplug at the mains.

2. Turn the cover anti-clockwise to remove.

3. Screw out the bulb by turning it anti-clockwise and replace

with a bulb of the same type.

4. Slide the new seals and the clamping ring onto the glass

cover in the right order.

5. Screw the glass cover with the seals back on again.

6. Connect the appliance to the mains and reset the clock.

Never operate the appliance without the glass cover and seals.

Replacing the glass cover or seals

Any damaged glass cover or seals must be replaced. Please

provide the after-sales service with the E number and FD

number of your appliance.

The appliance is not in operation. A cook-

ing time is shown in the display.

The rotary selector was accidentally oper-

ated

Press the

% button

The

n button was not pressed after mak-

ing the setting

Press the n button or cancel the setting

with the

% button

“Fill water tank” appears even though the

water tank is full

The water tank has not been inserted

properly

Slide in the water tank until it engages.

The detection system is not working Call the after-sales service

“Fill water tank” appears even though the

water tank is not yet empty, or the water

tank is empty but “Fill water tank” does not

appear

The water tank is dirty. The mobile water

level indicators are jammed

Shake and clean the water tank. If the

parts cannot be released, obtain a new

water tank from the after-sales service.

The water tank empties for no discernible

reason. The evaporator dish is overflowing

The water tank was not closed properly Close the lid until you feel it engage.

The tank lid seal is dirty Clean the seal

The seal in the tank cover is defective Obtain a new water tank from the after-

sales service

The evaporator dish has boiled empty

even though the water tank is full.

The water tank has not been inserted

properly

Slide in the water tank until it engages

The feed line is blocked Descale the appliance. Check whether the

water hardness range is set correctly

“Empty tank/Clean?” appears in the dis-

play

The appliance has not been used for at

least two days and the water tank is full

Empty and clean the water tank. Always

empty the water tank after cooking

There is a "pop" noise during cooking Cold/warm effect with frozen food, caused

by the steam

This is normal

When you cook with steam, a lot of steam

is created

The appliance is being automatically cali-

brated

This is normal

When cooking with steam, there is again a

lot of steam

The appliance is unable to calibrate itself

automatically if cooking times are too

short

Restore the appliance to the factory set-

ting (see section: Basic settings). Then

start steaming at 100 °C for 20 minutes

Steam escapes from the ventilation slots

during cooking

This is normal

The appliance is not producing steam

properly

Limescale has formed in the appliance Start the descaling programme.

An “E...” fault message appears in the dis-

play

Technical fault.

Press the

0 button to delete the error

message. Reset the clock if required.

If the error message appears again, call

the after-sales service

The fault message “E011” appears on the

display

A button was pressed for too long or is

jammed

Press the

0 button to clear the fault mes-

sage. Press all of the buttons individually

and check if they are clean

The appliance is not heating. “Demo” is

shown on the display

A button combination was actuated Disconnect the power supply and recon-

nect it after 10 seconds. Within 2 minutes,

press the

D button for 4 seconds

Problem Possible cause Notes/remedy

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch HBC 26D553 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bosch HBC 26D553

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info