Bedienungsanleitung Bosch HNG6764W6 (Seite 22 von 80) (Englisch)

601053

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

en Steam

Filling the water tank

The water tank is located behind the control panel.

Before starting an operation with steam, open the

control panel and fill the water tank with water.

Make sure that you have set the water hardness range

correctly. ~ "Basic settings" on page 28

:Warning – Risk of injury and risk of fire!

Only fill the water tank with water or with the descaling

solution that is recommended by us. Do not pour any

flammable liquids (e.g. alcoholic drinks) into the water

tank. Due to hot surfaces, vapours from flammable

liquids may catch fire in the cooking compartment

(explosion). The appliance door may spring open. Hot

steam and jets of flame may escape.

:Warning – Risk of burns!

The water tank may heat up while the appliance is in

operation. Wait until the water tank has cooled down

after the previous appliance operation. Remove the

water tank from the water tank recess.

Caution!

The appliance may become damaged due to the use of

unsuitable liquids.

Do not use distilled water, highly chlorinated tap water

(> 40 mg/l) or other liquids.

Only use cold, fresh tap water, softened water or

uncarbonated mineral water.

Notes

■ If your water is very hard, we recommend that you

use softened water.

■ If you use only softened water, you can set your

appliance to the "softened" water hardness range.

■ If you use mineral water, set the water hardness

range to "4 very hard".

■ If you use mineral water, you must only use non-

carbonated mineral water.

1. Touch the v field.

The control panel is automatically pushed forwards.

2. Pull the control panel forwards with both hands and

then push it upwards until it locks into place (Fig. !).

3. Lift the water tank and remove it from the water tank

recess (Fig. ").

4. Press down on the lid along the seal to prevent

water from leaking out of the water tank.

5. Fill the water tank with cold water up to the “max.”

mark (Fig. #).

6. Insert the filled water tank (Fig. $). Ensure that the

water tank locks into place behind both holders ‚

(Fig. %).

7. Slowly push the control panel downwards and then

towards the rear until it is closed completely.

The water tank has been filled. You can start

operations with steam.

Refilling the water tank

If the water tank runs dry during a steam operation, a

message appears on the display prompting you to fill

up the water tank.

Notes

■ Steam-assisted operations continue without adding

steam.

■ If the water tank runs dry during the operation with

the Dough proving or Reheating settings, the

operation is interrupted. Fill the water tank.

1. Open the control panel.

2. Remove and refill the water tank.

3. Insert the filled water tank and close the control

panel.



I

I

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch HNG6764W6 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bosch HNG6764W6

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info