745983
30
Zoom out
Zoom in
Vorherige Seite
1/40
Nächste Seite
en Troubleshooting
30
Fault Cause and troubleshooting
lights up in the display and no
settings can be made on the ap-
pliance.
Childproof lock is activated.
Use the button to deactivate the childproof lock.
→"Childproof lock", Page18
flashes in the display and the
appliance will not start.
The cooking compartment is too hot for the selected operation.
1. Switch off the appliance and allow it to cool down.
2. Restart the operation.
appears in the display. The maximum cooking time has been reached. To prevent an unwanted per-
manent operation, the appliance automatically stops heating after several hours
if the settings are unchanged.
Switch off the appliance.
You can configure new settings if required.
Tip:To prevent the appliance from switching off when you do not want it to,
e.g. for an extremely long preparation time, set a cooking time.
→"Time-setting options", Page13
- appears in the display. There is too much water in the steam system. The water cannot be pumped
back into the water tank.
1. Empty the water tank and insert the empty water tank.
→"Emptying the water tank", Page12
2. Reset the time.
→"Setting the time on the clock", Page14
3. Switch the appliance off and on again.
4. Run "Descaling interrupted" in full.
→"Descaling interrupted", Page25
A message with appears in the
display, e.g. - .
Electronics fault
1. Press the button.
If required, reset the time.
aIf the fault was a one-off, the error message disappears.
2. If the error message appears again, call the after-sales service. Quote the ex-
act error message and the E no. of your appliance.
→"Customer Service", Page31
lights up permanently in the
display.
The water tank is empty.
Fill the water tank.
→"Filling the water tank", Page12
The water tank has not been put in fully.
Slide the water tank back in fully.
The water tank is leaking.
Order a new water tank.
The sensor is defective.
Call the after-sales service.
→"Customer Service", Page31
lights up in the display. Build-up of limescale in the appliance.
Run the descaling programme in full.
→"Descaling", Page24
appears in the display. The power supply has been disconnected or the appliance has been switched
off during the descaling process.
Run the interrupted descaling programme in full.
→"Descaling interrupted", Page25
During operation with steam as-
sistance, steam escapes from the
ventilation slots.
Steam escapes for physical reasons.
Wait until the cooking with steam assistance ends.
After the end of cooking with steam assistance, no more steam will escape
after a short time.
After using the steam assistance,
the cooking result is too dry or
too moist.
Steam intensity set incorrectly.
Set a higher or lower steam intensity.
HomeConnect is not working cor-
rectly.
Different causes are possible.
Go to www.home-connect.com.
30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bosch HRS538BS6B wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info