Converting the cooker to another
type of gas
If the appliance is to be supplied with a type
of gas other than that intended for it (this is
indicated on the label which is attached to
the back of the appliance or to the packag-
ing), the burner nozzles must be changed
as follows:
• Remove the hob pan supports and
remove the burners from their fittings;
• Unscrew the nozzles (fig. 13) using a 7 mm
socket spanner and replace them with noz-
zles suitable for the new type of gas (see
table 1: Nozzle setting on page 43).
• Replace all the components in the reverse
order.
Minimum setting
• Turn the control knob to minimum;
• Now remove the control knob and use a
screwdriver to turn the setting screw (Z)
inside the gas tap (fig. 14) (unscrewing the
screw increases the minimum, while tight-
ening the screw reduces it) until a small,
even flame is achieved. NB: The setting
screw must be as tight as possible for liq-
uefied petroleum gases.
• Make sure that the burner flame does not
go out if you turn the knob from the max-
imum to the minimum very quickly.
Installation instructions
GB
42
