Bedienungsanleitung Bosch MCP72GPB (Seite 11 von 112) (Alle Sprachen)

773071

Zoom out

Zoom in

Vorherige Seite

1/112

Nächste Seite

 

Before using for the

first time

Before the new appliance can be used,

this must be fully unpacked, cleaned and

assembled. To do this, perform the following

steps:

1. Remove the motor unit, glass carafe

and all accessories from the packaging.

2. Remove the packaging material that is

present.

3. Check all parts for completeness.

X Fig. A / B

4. Inspect all parts for visible damage.

Caution!

Never operate a damaged appliance!

5. Thoroughly clean and dry all parts

before using for the first time.

X “Care and daily cleaning” see

page 12

Preparing the citrus press

and glass carafe

X Fig. C

1. Insert the collecting tray into the motor

unit.

Caution!

Inspect the discharge valve before inserting

the collecting tray. It must not be blocked by

a foreign object.

2. Place the filter insert into the collecting

tray and rotate until it clicks into place.

3. Position the pressing cone on the drive

shaft.

W Risk of electric shock!

Never manually move the pressing cone/

drive shaft.

The citrus press is prepared.

4. Place the glass carafe on the saucer.

Note: Always use the saucer. This provides

anti-slip protection and noise reduction.

5. Place the prepared citrus press onto the

glass carafe until the opening is sealed

tight.

The citrus press is prepared for use with the

glass carafe.

Operation

Using the citrus press with

the glass carafe

X Fig. D

Use the citrus press with the glass carafe

in order to press larger quantities of juice,

such as freshly squeezed orange juice.

Caution!

The juice is collected in the glass carafe.

The volume capacity of the glass carafe is

1.0 l. End the pressing procedure before the

juice reaches the bottom edge of the motor

unit.

1. Position the prepared citrus press with

glass carafe on a stable and level work

surface.

2. Connect the mains cable to the socket.

3. Position the halved citrus fruits with the

cut surface on the pressing cone and

press down.

The citrus press starts running once the

pressed product is pressed onto the

pressing cone. The pressing cone rotates

either clockwise or anticlockwise. Once the

pressed product is released and pressed

once again, the pressing cone changes

its rotation direction. If excess pressure

is applied, the pressing cone changes

the rotation direction in rapid succession.

Reduce the pressure until the pressing

cone rotates normally once more.

Caution!

Press a maximum of 10 fruits (approx. 2 kg)

one after the other. Then halt the pressing

procedure until the motor unit has once

again reached room temperature. Only then

should the pressing procedure be resumed.

Notes:

– To obtain the largest amount of juice,

the pressing procedure should be

repeated a few times.

– The filter insert with the rough peel and

the seeds should be emptied if required.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch MCP72GPB Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info