746499
23
Zoom out
Zoom in
Vorherige Seite
1/121
Nächste Seite
23
en Re-adjustment of tools
Mix all ingredients with the professional
flexible beating whisk for approx.
½ minute at setting
2, and then for
approx. 2-3 minutes at setting 7.
Maximum quantity: 2½ x basic recipe
Shortcrust pastry
Basic recipe
125 g butter (room temperature)
100-125 g sugar
1 egg
1 pinch salt
A little lemon peel or vanilla sugar
250 g flour
Baking powder if required
Mix all ingredients with the profes-
sional flexible beating whisk for about
½ minute at setting
2, then for about
2-3 minutes at setting 6.
From 500 g flour:
Knead ingredients with
the kneading hook for
about ½ minute at setting 2, then
for about 2-3 minutes at setting 7.
Maximum quantity: 4x basic recipe
Yeast dough
Basic recipe
500 g flour
1 egg
80 g fat (room temperature)
80 g sugar
200-250 ml lukewarm milk
25 g fresh yeast or 1 packet dried yeast
Peel from ½ lemon
1 pinch salt
Mix all ingredients with the kneading
hook for approx. ½ minute at setting
2,
then for approx. 3-6 minutes at setting 3.
Maximum quantity: 3x basic recipe
Pasta dough
Basic recipe
500 g flour
250 g eggs (approx. 5x)
2–3 tbsp (20–30 g) cold water as
required
Mix all ingredients for about 3 to 5 minutes
at setting 3 until a dough forms.
Maximum quantity: 1,5 x basic recipe
Bread dough
Basic recipe
1000 g flour
3 sachets dried yeast
2 tsp salt
660 ml warm water
Mix all ingredients with the kneading
hook for approx. ½ minute at setting 1,
then for approx. 4-5 minutes at setting 3
.
Maximum quantity: 1,5 x basic recipe
Re-adjustment of tools
W Risk of injury!
Pull out the mains plug before re-adjusting.
Caution!
Only re-adjust tools in small steps. It must
be possible to completely lower the swivel
arm, and when doing so, the tools should
not catch on the bottom or on the edge of
the bowl. The optimum distance between
the tools and the bowl is 3 mm.
X Image sequence K
Insert the professional stirring whisk and
check the current setting.
Press the release button and raise
the swivel arm to the stop.
Hold the tool with your hand. Release
the lock nut in a clockwise direction
using a spanner wrench (10 mm).
Adjust the distance to the bowl by
turning the tool (1 whole turn corre-
sponds to a height adjustment of 1 mm).
Turn anticlockwise:
Distance to bowl is reduced.
Turn clockwise:
Distance to bowl is increased.
Press the release button and push the
swivel arm down until it locks into place.
Check the tool distance. The optimum
distance between the tools and the bowl
is 3 mm. Adjust if necessary.
Once the distance is perfectly adjusted,
press the release button and move the
swivel arm back.
Hold the tool with your hand. Turn the
lock nut in an anticlockwise direction
using a spanner wrench (10 mm).
23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bosch MUM9A66R00 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info