Bedienungsanleitung Bosch PCP6A5B90 (Seite 7 von 12) (Englisch)

746035

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

en Getting to know your appliance

It is essential to ensure that all the burner parts and pan

supports are correctly installed for the appliance to

work correctly. Do not swap the burner caps around.

Always remove the pan supports carefully. When

moving a pan support, the pan supports next to it may

also move.

Accessories

Depending on the model, the hob may include the

following accessories. These can also be acquired from

the Technical Assistance Service.

--------

Code

The manufacturer accepts no liability if these

accessories are not used or are used incorrectly.

Burner parts

1 Ignition plug

2 Thermocouple

3 Burner cup

4 Burner cap















Additional wok grid

Only suitable for use on wok

burners. Use cookware with a

rounded base.

To extend the service life of the

appliance, we recommend using

the additional wok grid.

Additional espresso maker

grid

Only suitable for use on the

smallest burner. Use cookware

with a diameter of less than

12 cm.

Simmer plate

This accessory part is only suita-

ble for simmering. It can be

used with the economy burner

or the standard-output burner. If

your hob has several standard-

output burners, we recommend

placing the simmer plate on the

rear or front-right standard-out-

put burner.

Place the accessory component

with the projections facing

upwards on the holder; never

place it directly on the burner.

Simmer cap

Only use the cap for cooking

with minimal power. Place the

simmer cap on the cover of the

economy burner. Always place

cookware on the pan support,

never directly on the simmer

cap.

HEZ298107 Additional wok grid: Cast iron (4-5 kW)

HEZ298108 Additional wok grid: Cast iron (mini wok

burner)

HEZ298110 Additional wok grid: Enamelled steel

HEZ298115 Additional espresso maker grid

HEZ298105 Simmer Plate

HEZ211310 Simmer cap

Gas burners en

ÄGas burners

Gas bur ner s

Switching on manually

1. Press the control knob for the selected burner and

turn it anticlockwise to the highest power setting.

2. Hold an igniter or a naked flame (such as a lighter or

a match) against the burner.

Automatic ignition

If the hob has automatic ignition (ignition plugs):

1. Press the control knob for the selected burner and

turn it anticlockwise to the highest power level.

While the control knob is held down, all the burners

will generate sparks. The flame ignites. Wait a few

seconds.

2. Release the control knob.

3. Turn the control knob to the required position.

If the burner does not ignite, switch it off and repeat the

steps described above. This time, hold the control knob

down for longer (up to 10 seconds).

:Warning – Risk of deflagration!

If the flame does not ignite after 15 seconds, switch off

the burner and open a window or the door to the room.

Wait at least one minute before switching the burner on

again.

Note: It is important to keep the appliance clean. If the

ignition plugs are dirty, this may cause ignition

problems. Clean the ignition plugs regularly with a

small, non-metallic brush. Take care to prevent the

ignition plugs from suffering any heavy knocks.

Safety system

Your hob is equipped with a safety system

(thermocouple) that cuts off the gas when the burners

are accidentally switched off.

To ensure that this device is active:

1. Switch on the burner as usual.

2. Without releasing the control knob, press and hold it

down firmly for 4 seconds after lighting the flame.

Switching off a burner

Turn the corresponding control knob clockwise to the 0

setting.

A few seconds after the burner is switched off, a sound

(thud) will be produced. This is not a fault - this means

that the safety device is no longer operating.

Main switch/Hob lock (Main Switch)

The hob may have a main switch to cut off the mains

gas supply and switch off all the burners at the same

time. This switch is very practical if there are children in

the house or, if for any reason, all the burners must be

switched off quickly.

To lock the hob:

Press the main switch.

This switches off all the burners which are on. The hob

is locked.

To unlock the hob:

1. Turn all the control knobs to the "off" position.

2. Press the main switch and turn it fully clockwise.

The mains gas supply is turned on. You can now use

your hob normally.

Warnings

It is normal to hear a soft whistling noise while the

burner is operating.

When first used, it is normal for the burner to give off

odours. This does not pose any risk and does not

indicate a malfunction. They will disappear in time.

An orange-coloured flame is normal. This is caused by

the presence of dust in the atmosphere, spilt liquids,

etc.

In the event of the burner flames being accidentally

extinguished, turn off the burner control and do not

attempt to re-ignite the burner for at least one minute.

$ %

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch PCP6A5B90 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bosch PCP6A5B90

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info