Bedienungsanleitung Bosch PIL811T14E (Seite 11 von 16) (Englisch)

746114

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Care and cleaning

The advice and warnings contained in this section aim to guide

you in cleaning and maintaining the hob, so that it is kept in the

best possible condition

Hob

Cleaning

Clean the hob after each use. This prevents food remains left

on the surface from burning. Wait until the hob is cold enough

before attempting to clean it.

Only use cleaning products specifically designed for glass-

ceramic hobs. Follow the instructions provided on the

packaging.

Do not use:

■ Abrasive products

■ heavy-duty cleaners, like oven sprays and stain removers

■ Pads that may scratch

■ High-pressure or steam cleaners

Glass scraper

Remove dried-on food remains using a glass scraper.

1. Release the scraper safety catch

2. Use the blade to clean the hob surface

Do not attempt to clean the hob surface with the base of the

scraper. This could result in scratching.

ã=Risk of injury!!

The blade is extremely sharp. Risk of cuts. Protect the blade

when not in use. Replace the blade immediately when any

imperfections are found.

Care of the appliance

Apply an additive to protect and preserve the hob. Follow the

advice and warnings provided with the product.

Hob frame

In order to avoid damage to the hob frame, follow the

indications below:

■ Use only slightly soapy hot water

■ Do not use sharp or abrasive products

■ Do not use a glass scraper

Fixing malfunctions

Malfunctions are generally caused by minor faults. Before

contacting the Technical Assistance Service, make sure you

have read the following recommendations and warnings.

Indicator Malfunction Measure

none The electric power supply has been inter-

rupted.

Use other electrical appliances to check if there has been a power

cut.

The appliance has not been correctly con-

nected following the connection diagram.

Make sure that the appliance has been connected correctly.

Electronic system malfunction. If in the above checks, the malfunction is not resolved, contact the

Technical Assistance Service.

“ flashing

The control panel is wet or an object is

resting on it.

Dry the control panel area or remove the object.

“§ + number /

š + number /

¡ + number

Electronic system malfunction. Disconnect the hob from the mains. Wait 30 seconds or so, then con-

nect it again.*

”‹ / ”Š

There is an internal error in the system. Disconnect the hob from the mains. Wait 30 seconds or so, then con-

nect it again.*

”ƒ

The electronic system has overheated and

the corresponding hotplate has been

switched off.

Wait until the electronic system has cooled down completely. Then

press any symbol on the hob.*

”…

The electronic system has overheated and

all hotplates have been switched off.

—‚

Supply voltage outside normal operating

limits.

Please contact the local electricity board.

—ƒ / —„

The hotplate has overheated and switched

off to protect its working surface.

Wait until the electronic system has cooled down sufficiently before

switching it back on.

* If the warning persists call the Technical Assistance Service.

Do not place hot pans on the control panel.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch PIL811T14E Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bosch PIL811T14E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info