Bedienungsanleitung Bosch PSM 10.8 LI T15 (Seite 14 von 74) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

591473

Zoom out

Zoom in

Vorherige Seite

1/74

Nächste Seite

14 | English

1 609 92A 0UE | (7.1.15) Bosch Power Tools

Operation

Starting Operation

Switching On and Off

To start the machine, push the On/Off switch 2 towards the

front to “I”.

To switch off the machine, push the On/Off switch 2 towards

the rear to “0”.

To save energy, only switch the power tool on when using it.

Battery Charge-control Indicator/Overload Indicator

The battery charge-control indicator/overload indicator 1 in-

dicates the charge condition of the battery and overload con-

ditions when the machine is switched on.

During operation with increased load, the battery charge-con-

trol indicator/overload indicator 1 flashes green. This indi-

cates a higher operation level.

When using the machine as intended for, it cannot be subject

to overload. In case of excessive loading, the battery charge-

control indicator/overload indicator 1 flashes red for a dura-

tion of up to approx. 2 seconds. In case of prolonged over-

loading, the motor gradually stops within one second and the

battery charge-control indicator/overload indictor 1 flashes

red for approx. 5 seconds.

When exceeding the allowable battery temperature of 70 °C,

the electronics immediately switch the machine off until it is

in the optimal operating-temperature range again. The bat-

tery charge-control indicator/overload indicator 1 flashes

red for approx. 5 seconds.

Note: If the machine should automatically switch off because

of a discharged or overheated battery, make sure to set the

machine’s On/Off switch 2 to off. Charge the battery and al-

low it to cool down before restarting the machine. Otherwise

the battery can become damaged.

Protection Against Deep Discharging

The lithium-ion battery is protected against deep discharging

by the “Electronic Cell Protection (ECP)”. When the battery is

empty, the machine is switched off by means of a protective

circuit: The inserted tool no longer rotates and the battery

charge-control indicator/overload indicator 1 flashes red for

approx. 5 seconds.

Working Advice

 Wait until the machine has come to a standstill before

placing it down.

The removal capacity during sanding is mainly determined by

the selection of the sanding sheet.

Only flawless sanding sheets achieve good sanding capacity

and extend the service life of the machine.

Pay attention to apply uniform sanding pressure; this increas-

es the working life of the sanding sheets.

For precise on-the-spot sanding of edges, corners and hard to

reach areas, it is also possible to work only with the tip or an

edge of the sanding plate.

A sanding sheet that has been used for metal should not be

used for other materials.

Use only original Bosch sanding accessories.

Maintenance and Service

Maintenance and Cleaning

 Before any work on the machine itself (e. g. mainte-

nance, tool change, etc.) as well as during transport

and storage, remove the battery from the power tool.

There is danger of injury when unintentionally actuating

the On/Off switch.

 For safe and proper working, always keep the machine

and ventilation slots clean.

When the battery is no longer operative, please refer to an au-

thorised after-sales service agent for Bosch power tools.

After-sales Service and Application Service

Our after-sales service responds to your questions concern-

ing maintenance and repair of your product as well as spare

parts. Exploded views and information on spare parts can al-

so be found under:

www.bosch-pt.com

Bosch’s application service team will gladly answer questions

concerning our products and their accessories.

In all correspondence and spare parts order, please always in-

clude the 10-digit article number given on the type plate of

the machine.

Great Britain

Robert Bosch Ltd. (B.S.C.)

P.O. Box 98

Broadwater Park

North Orbital Road

Denham

Uxbridge

UB 9 5HJ

At www.bosch-pt.co.uk you can order spare parts or arrange

the collection of a product in need of servicing or repair.

Tel. Service: (0344) 7360109

E-Mail: boschservicecentre@bosch.com

Ireland

Origo Ltd.

Unit 23 Magna Drive

Magna Business Park

City West

Dublin 24

Tel. Service: (01) 4666700

Fax: (01) 4666888

LED Capacity

Continuous lighting, green

≥ 30%

Continuous lighting, red

< 30%

OBJ_BUCH-1531-003.book Page 14 Wednesday, January 7, 2015 10:29 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch PSM 10.8 LI T15 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info