Bedienungsanleitung Bosch Purion BUI215 - 2021 (Seite 16 von 100) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

780160

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

English – 4

Displays and configurations of the

on-board computer

Battery charge indicator

The battery charge indicator (g) displays the eBike battery's

state of charge. The state of charge of the eBike battery can

also be checked on the LEDs of the battery itself.

In the indicator (g), each bar in the battery symbol repres-

ents approximately 20% capacity:

The eBike battery is fully charged.

The eBike battery should be recharged.

The LEDs of the battery charge indicator on the

battery go out. The capacity for assisting the drive

has been used up, and assistance is gently

switched off. The remaining capacity is made

available for the lighting. The indicator flashes.

The capacity of the eBike battery is enough for

about two hours of lighting.

Speed and distance indicators

The speedometer (a) always displays the current speed.

Indicator (i) always displays the last setting as standard. Re-

peated medium-length presses of the button– will display

the trip distance TRIP, the total distance TOTAL and the

range of the battery RANGE one after the other. (Briefly

pressing the button– will decrease the assistance level.)

To reset the trip distance TRIP, select the trip distance TRIP

and simultaneously press and hold the buttons + and –.

The display will initially show RESET. If you continue to press

both buttons, the trip distance TRIP will be set to 0.

To reset the range of the battery RANGE, select the battery

range RANGE and simultaneously press and hold the but-

tons + and –. The display will initially show RESET. If you

continue to press both buttons, the trip distance TRIP will be

set to 0.

You can switch the displayed values from kilometres to miles

by holding down the button – and briefly pressing the

on/off button (1).

The versions of the subsystems and their model part num-

bers can be displayed for the purposes of servicing,

provided the subsystems divulge this information (depend-

ent on the subsystem). With the system switched off, simul-

taneously press the buttons– and + and then press the on/

off button(1).

The USB port is reserved for connecting diagnostic systems.

The USB port does not have any other function.

uThe USB connection must always be completely

sealed with the protective cap (8).

Action Buttons Duration

Switch on on-board computer

Switch off on-board computer

Increase assistance +

Action Buttons Duration

Decrease assistance –

Display TRIP, TOTAL, RANGE,

assistance modes

–

Switch on bike lights +

Switch off bike lights +

Reset trip distance – +

Activate push assistance

Implement push assistance WALK

2. Any

Switch from kilometres to miles –1. Keep

pressed

Display the versions A)B) – +1. Keep

pressed

Adjust display brightnessC) – +

– or +

1. Keep

pressed

A) The eBike system must be switched off.

B) The information is shown as scrolling text.

C) The display must be switched off.

1 207 020 XBP | (11.03.2020) Bosch eBike Systems

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch Purion BUI215 - 2021 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info