Bedienungsanleitung Bosch PWS 1000 (Seite 13 von 28) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

543995

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

1 609 929 R38 | (26.6.08) Bosch Power Tools

14 | English

Dust/Chip Extraction

f Dusts from materials such as lead-containing

coatings, some wood types, minerals and

metal can be harmful to one’s health. Touch-

ing or breathing-in the dusts can cause aller-

gic reactions and/or lead to respiratory infec-

tions of the user or bystanders.

Certain dusts, such as oak or beech dust, are

considered as carcinogenic, especially in con-

nection with wood-treatment additives (chro-

mate, wood preservative). Materials contain-

ing asbestos may only be worked by

specialists.

– Use dust extraction whenever possible.

– Provide for good ventilation of the working

place.

– It is recommended to wear a P2 filter-class

respirator.

Observe the relevant regulations in your coun-

try for the materials to be worked.

Operation

Starting Operation

f Observe correct mains voltage! The voltage

of the power source must agree with the

voltage specified on the nameplate of the

machine. Power tools marked with 230 V can

also be operated with 220 V.

When operating the machine with power from

mobile generators that do not have sufficient re-

serve capacity or are not equipped with suitable

voltage control with starting current amplifica-

tion, loss of performance or untypical behavior

can occur upon switching on.

Please observe the suitability of the power gen-

erator being used, particularly with regard to the

mains voltage and frequency.

Switching On and Off

To start the power tool, push the On/Off switch

2 forwards.

To lock the On/Off switch 2, press the On/Off

switch 2 down at the front until it latches.

To switch off the power tool, release the On/Off

switch 2 or, if it is locked, briefly push down the

back of the On/Off switch 2 and then release it.

f Check grinding tools before using. The grind-

ing tool must be mounted properly and be

able to move freely. Carry out a test run for

at least one minute with no load. Do not use

damaged, out-of-centre or vibrating grinding

tools. Damaged grinding tools can burst and

cause injuries.

Working Advice

f Clamp the workpiece if it does not remain

stationary due to its own weight.

f Do not strain the machine so heavily that it

comes to a standstill.

f Grinding and cutting discs become very hot

while working; do not touch until they have

cooled.

Rough Grinding

f Never use a cutting disc for roughing.

The best roughing results are achieved when set-

ting the machine at an angle of 30° to 40°. Move

the machine back and forth with moderate pres-

sure. In this manner, the workpiece will not be-

come too hot, does not discolour and no grooves

are formed.

Flap Disc

With the flap disc (accessory), curved surfaces

and profiles can be worked.

Flap discs have a considerably higher service life,

lower noise levels and lower sanding tempera-

tures than conventional sanding sheets.

Cutting Metal

f For cutting metal, always work with the pro-

tection guard for cutting 12.

When cutting, work with moderate feed, adapted

to the material being cut. Do not exert pressure

onto the cutting disc, tilt or oscillate the ma-

chine.

Do not reduce the speed of running down cutting

discs by applying sideward pressure.

OBJ_BUCH-758-001.book Page 14 Thursday, June 26, 2008 9:29 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch PWS 1000 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info