Bedienungsanleitung Bosch Rotak 32 Ergoflex (Seite 11 von 191) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

708178

Zoom out

Zoom in

Vorherige Seite

1/191

Nächste Seite

English | 11

Bosch Power Tools F 016 L81 402 | (19.1.16)

Do not tilt the machine when starting

or switching on the motor, except if

the machine has to be tilted for start-

ing in long grass. In this case, do not

tilt it more than absolutely necessary

and tilt only the part which is away

from the operator. Always ensure

that both hands are in the operating

position before returning the ma-

chine to the ground.

Switch on the motor according to the

instructions with feet well away from

rotating parts.

Do not put hands or feet near or un-

der rotating parts.

Always stand clear of the discharge

zone when operating the machine.

Never pick up or carry the machine

while the motor is running.

Do not modify this product. Unau-

thorized modifications may impair

the safety of your product and may

result in increased noise and vibra-

tion.

Regularly inspect the supply cable

and any extension cables. Do not

connect damaged cables to the sup-

ply or touch a damaged cable before

it is disconnected from the supply.

A damaged cable can lead to contact

with live parts. Beware electric shock

hazard.

Remove the plug from the socket:

– Whenever you leave the machine.

– before clearing a blockage,

– before checking, cleaning or working

on the machine,

– after striking a foreign object. Inspect

the machine for damage and make re-

pairs as necessary,

– if the machine starts to vibrate abnor-

mally (check immediately).

Connecting to the mains

The voltage indicated on the rating

plate must correspond to the voltage

of the power source.

We recommend that this equipment

is only connected into a socket which

is protected by a circuit-breaker that

would be actuated by a 30 mA residu-

al current.

Only use or replace power supply ca-

bles for this unit which correspond to

the types indicated by the manufac-

turer. See the operating instructions

for the order no. and types.

Never touch the mains plug with wet

hands.

Do not run over, crush or pull the

power supply cord or extension cord,

otherwise it may be damaged. Pro-

tect the cable from heat, oil and sharp

edges.

The extension lead must have a cross

section in accordance with the oper-

ating instructions and be protected

against splashed water. The connec-

tion must not be in water.

Always wear gardening gloves when

handling or working near the sharp

blades.

Electrical Safety

Warning! Switch off, remove plug

from mains before adjusting,

cleaning or if cable is cut, damaged

or entangled.

The blades continue to rotate for a

few seconds after the machine is

switched off.

OBJ_BUCH-1739-003.book Page 11 Tuesday, January 19, 2016 9:30 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch Rotak 32 Ergoflex Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info