en Operating the appliance
20
Remaining running time
display
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display H.
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).
Timer programming
Timer programming *
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press button P until the digital
display H jumps to œ:‹‚.
4. Press button P until the displayed
time corresponds with your
requirements.
5. Press START button @, timer
programming is activated.
6. To delete the preselected starting
time, press the button P until œ is
indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the
value ‹:‹‹ is indicated on the numerical
display H.
Switching off automatically
after the end of
the programme *
Switching off aut omatically after the end of the programme
* depending on model
To save energy, the dishwasher is
switched off 1 minute after the
programme ends (factory setting).
Automatic disconnection
can be adjusted from ˜:‹‹ to ˜:‹ƒ.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press and hold down the START
button @.
4. Rotate programme selector 8
until ˜:‹... s indicated on the digital
display H.
5. Release button.
The factory set value ˜:‹‚ is lit on
the digital display H.
To change the setting:
1. Rotate programme selector 8 until
the required value is indicated on the
digital display H.
2. Press START button @.
The set value is saved.
˜:‹‹ Appliance does not switch off
automatically
˜:‹‚ Off after 1 min
˜:‹ƒ Off after 120 min
