en Operating the appliance
38
Switching off the appliance
Short time after the end of the
programme:
1. Open the door.
2. Switch off ON/OFF switch (.
3. Turn off tap (does not apply to
appliances with Aqua-Stop).
4. Remove the utensils when they have
cooled down.
Note: When the programme ends,
leave the appliance to cool down a
while before opening it. This will prevent
steam from escaping and causing
long-term damage to your built-in
furniture.
Interrupting the programme
Caution!
Expansion (overpressure) may cause
the appliance door to jump open and/or
water to escape! If the door was opened
on an appliance which has a hot water
connection or is heated, always leave
the door ajar for several minutes and
then close.
1. Open the door.
2. Switch off ON/OFF switch (.
The LEDs go out. The programme
is saved.
3. To continue the programme, switch
on the ON/OFF switch ( again.
4. Close the door.
Terminating the programme
(Reset)
Terminating the programme
1. Open the door.
2. Press the START button )* and
hold for 3 seconds
The display window at the top @
and the front display * )2 show:
"Program was terminated".
3. Close the door.
The programme sequence lasts
approx. 1 min. The display window
at the top @ shows: “Finished”.
4. Open the door.
5. Switch off ON/OFF switch (.
6. Close the door.
* depending on the features of your
dishwasher
Changing the programme
When the START button )* has been
pressed, the programme cannot be
changed. The only way a programme
can be changed is by Cancel
programme (Reset).
