Bedienungsanleitung Bosch TES50221RW (Seite 9 von 128) (Englisch, Holländisch, Französisch, Polnisch)

537417

Zoom out

Zoom in

Vorherige Seite

1/128

Nächste Seite

TES502 | 02/2013

5en

Display messages

The display (15) shows not only the current

operating status, but also various mes-

sages that give you status information or

let you know when you need to take action.

As soon as you have taken the necessary

action, the message disappears and the

menu for drink selection is displayed again.

Before using for the

 rst time

General

Fill the water tank with fresh, cold, uncar-

bonated water only, and preferably use

only beans for fully automatic coffee and

espresso machines. Do not use coffee

beans that have been glazed, caramelised

or treated with other additives containing

sugar, since they will block the brewing unit.

The water hardness setting can be adjusted

on this appliance. The factory default setting

for the water hardness is 4. Check the

water hardness with the enclosed test strip.

If the check reveals a value other than 4,

change the setting on the appliance accord-

ingly after switching on (see “Menu settings”

Water hardness on page 7).

Switching on the appliance

1. Remove the protective  lm.

2. Place the fully automatic espresso

machine on a  at, water-resistant

surface that can take its weight. Make

sure that the machine’s ventilation slots

remain unobstructured.

Important: Only use the appliance in

frost-free rooms. If the appliance has been

transported or stored at temperatures below

0 °C, wait at least 3 hours before operation.

3. Pull the power cord out of the storage

compartment (20) and plug in. Adjust

the length of the cable by pushing it

back in or pulling it out. The easiest way

to do this is to place the appliance so

that its back is  ush with the edge of the

counter and either pull the cable down-

ward or push it upward.

4. Install the milk frother. Operate the

machine only after the milk frother (6)

has been fully assembled and installed.

5. Lift the lid of the water tank (17).

6. Remove and rinse the water tank (16)

and  ll it with fresh cold water.

Do not  ll above the max mark.

7. Replace the water tank (16) and push it

 rmly downward into place.

8. Close the lid of the water tank (17)

again.

9. Fill the bean container (1) with coffee

beans. (For preparation using ground

coffee, see “Preparation using

ground coffee” on page 9.)

10. Press the power switch O / I (9). The

display (15) shows the menu for setting

the display language.

11. Select the required display language

with the upper rotary knob (14). The

following languages are available:

English Nederlands

Français Italiano

Svenska Español

Polski Magyar

Türkçe Dansk

Norsk Suomi

Português Čeština

ελληνικα български

русский

12. Press the start button (10). The

language you selected is saved. The

display shows Pull milk frother.

13. Place a receptacle under outlet.

TES502_1RW.indb 5 21.02.2013 13:38:17

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch TES50221RW Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bosch TES50221RW

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info