112553
16
Zoom out
Zoom in
Vorherige Seite
1/56
Nächste Seite
16
Problem Possible cause Solution
Hot air in the “ cold” This is not a fault! Residual heat. The hot air disappears after a
programme. short period of time.
The light is flashing The start/stop button has been pressed It stops after 30 seconds or
during an ironing cycle: pause function. when start/stop is pressed.
The light flashes 10 times on plugging This indicates that the
the appliance into the electricity supply appliance is ready for
with the button band already lifted. operation.
The light flashes 10 times This indicates that the
on raising the appliance to its upper appliance is ready for
position when it is already plugged in. operation.
The preheating time has finished. This indicates that the
preheating time has finished
and you have 5 minutes to
press the Start/ Stop button
before the appliance switches
itself off.
Low air pressure in The ironing dummy has not been Fit the ironing dummy
the ironing dummy fitted properly. correctly.
The air filter is dirty. Clean the air filter.
Faulty ironing dummy. Replace the ironing dummy.
Excessive air pressure The airbag is not fitted properly. Check the airbag adjustment
in the ironing dummy. cords and adjust them
correctly
No air pressure in the The ironing dummy arms are twisted. Set the arms in the right
arms position.
The airbag arms are not inside the Insert the airbag arms in the
ironing dummy arms. ironing dummy arms. Fig. 25.
Ironing process too long. The 10 A version was used. Switch over to the 16 A
version if possible.
The ends of the The end of the cord has splipped into Press the button band adjuster
adjustment cords used to the gap on the button band. in and pull on the cord.
regulate size have
become hooked up on
the appliance.
The fuse triggers when The wrong connection current has Select the right connection
the appliance is been selected. current. See “Changing the
connected. connection current”.
You hear a noise on This is because the internal tube is This is not a fault and does
raising or lowering the sliding not affect correct operation
appliance. of the appliance.
Before calling the Technical Service
16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bosch THB 1500 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info