Bedienungsanleitung Bosch TWK8612P (Seite 11 von 102) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch)

765406

Zoom out

Zoom in

Vorherige Seite

1/102

Nächste Seite

Congratulations on the purchase of

your new Bosch appliance. You can find

further information about our products

on our website.

Parts and operating

controls

1 Kettle (with water level indicator)

2 Lid

3 Lid release button

4 O ON/OFF switch

5 Temperature indicator (illuminated)

6 + – button (temperature setting)

7 keep warm button

8 Limescale filter (removable)

9 Base

10 Cable tidy

Important: Use the kettle only with its

included base.

Only fill the kettle with water. Milk and

instant beverages will burn and damage

the appliance. Never operate the kettle

without water and do not overfill it;

observe the min and max markings. If

the kettle is too full, the water will boil

over!

Before using

for the first time

Remove any stickers or film.

Unroll the right amount of cable from the

cable tidy and plug it in.

Fill the kettle with water. Bring the water

to a boil and discard it. Repeat the

procedure. This will make sure that the

kettle is clean for normal use.

When the water comes to a boil for the

first time, add a tablespoon of white

vinegar.

Boiling water

Fill the kettle with fresh water through the

spout or the open lid (press lid release

button).

Check the amount by reading the water

level indicator markings min and max.

Close the lid until it locks and place the

kettle on the base.

Press the O ON/OFF switch. The kettle

emits a signal, and the factory-set

temperature (100°C) lights up. The water

is being heated.

By pressing button + or – you can set

the temperature to ca. 70°C, ca. 80°C,

ca. 90°C or ca. 100°C.

When the water has reached the selected

temperature, the kettle will switch off

automatically, the temperature indicator

goes off, and a signal sounds.

Note: The selected temperature can be

changed at any time while the kettle is

heating up. While the kettle heats up, the

current temperature lights up; the preset

temperature flashes until it has been

reached.

If the temperature cannot be set, this

indicates that the water in the kettle is hotter

than the desired temperature. The current

temperature will light up.

You can turn off the kettle at any time by

pressing the O ON/OFF switch again.

Warning: If you remove the kettle from

the base and replace it before the heating

process is over, the kettle will not continue

to heat the water. The selected settings will

be lost (reset to factory setting).

N.B.: Use the kettle only while the lid is

closed and the limescale filter is in place.

For physical reasons, the base may collect

some condensation water. This is normal; it

does not mean that the kettle leaks.

When you set the temperature to 100°C,

the kettle will turn off only after the water

has reached the boiling point, i.e. it will

bubble for a short period of time.

After boiling, let the kettle cool down for

5 minutes before refilling it with water.

Do not turn on the appliance if the kettle is

empty, otherwise the overheat control will

engage and the appliance will switch itself

off automatically.

WRisk of re!

Do not place the base or kettle on or near hot surfaces, e.g. hobs.

Avoid spatters of grease as the plastic may be damaged.

WRisk of scalding!

The appliance heats up during use. Make sure you only pick it up

by the handle and do not open the lid until the appliance has cooled

down. Only use the appliance when the lid is engaged.

If the appliance is lled above the “max” marking, there could be a

risk from splashes of boiling water.

WRisk of burns!

After the use the heating element surfaces can be subjected to

residual heat.

KWARNING: Do not use this appliance near bathtubs,

showers, basins or other vessels containing water.

WRisk of su󰀨ocation!

Do not allow children to play with packaging material.

WRisk of injury!

A misuse of the appliance can potentially lead to injury.

WCaution!

Cleaning surfaces which come into contact with foodstu󰀨s!

Please note the special information on cleaning in the instructions.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch TWK8612P Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info