Bedienungsanleitung Bosch Uni Condens 8000 F (Seite 5 von 48) (Englisch)

697430

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

Product Information

Uni Condens 8000 F – 6720867056 (2016/10)

H Combustion/room air

▶ Keep the combustion/ambient air free of corrosive

substances (e.g. halogenated hydrocarbons that

contain chlorine or fluorine compounds). This will

help to prevent corrosion.

▶ Keep the combustion air supply free of dust.

H Danger posed by explosive and easily

flammable materials

▶ Never use or store easily flammable materials

(e.g. paper, thinners, paints, etc.) near the

appliance.

H Risk of damage to the system from frost

When the heating system is not in operation

(e.g. controller switched off, fault shutdown),

there is a risk of it freezing when there is frost.

In order to protect the heating system from freezing

when shutting down or switching off for extended

periods:

▶ Drain the heating system and DHW pipework at the

lowest point.

H Inspection and servicing

▶ Recommendation for customers: Arrange a

maintenance and inspection contract with an

approved contractor, covering an annual inspection

and responsive maintenance.

▶ The user is responsible for ensuring the heating

system is safe and environmentally compatible.

▶ Immediately correct all faults to prevent system

damage!

▶ Use only genuine spare parts from the

manufacturer. Losses caused by the use of spare

parts and accessories not supplied by the

manufacturer are excluded from the manufacturer's

warranty.

H Handover to the user

When handing over, instruct the user how to operate

the heating system and inform the user about its

operating conditions.

▶ Explain how to operate the heating system and draw

the user's attention to any safety relevant action

▶ Explain that conversions and repairs must only be

carried out by a competent person.

▶ Point out the need for inspections and maintenance

for safe and environmentally-compatible operation.

▶ Leave the installation instructions and the

operating instructions with the user for

safekeeping.

2 Product Information

2.1 Declaration of Conformity

The design and operation of this product comply with European

Directives and the supplementary national requirements. Conformity

has been demonstrated by the CE marking.

You can ask for a copy of the declaration of conformity for this product.

For this see the contact address on the back cover of these instructions.

2.2 Determined use

The product may only be used for the heating of central heating water

and for DHW heating in closed-loop DHW and heating systems.

The product is only approved for open-flue mode.

Any other use is considered inappropriate. We take no responsibility for

damage caused through incorrect use.

When installing and operating the heating system observe the following:

• Standards, regulations and directives of the relevant country

• Data plate of boiler

• Requirements for the control unit ( chapter 7.1, page 25).

• Requirements for the burner ( chapter 4.2, page 13)

• Requirements for the safety equipment ( chapter 2.10, page 10)

• Requirements for the water quality of the heating water

( chapter 4.6, page 14)

2.3 Symbols at the boiler

2.4 Scope of delivery

▶ After delivery, check that all packaging is undamaged.

▶ Check the scope of delivery for completeness:

– Boiler body with casing

– Front cover

– Control unit retainer and cable conduit

(in the combustion chamber)

– Sound insulation strips

– Siphon in the combustion chamber

– Insulating rings for blast tube in the combustion chamber

– Technical documents

2.5 Required accessories

The following accessories are not part of the standard delivery, but are

required to operate the boiler:

• Burner

• Burner plate, drilled or undrilled

• Fitting assembly/boiler safety assembly

• Safety equipment

• Condensate neutraliser (if required by regulations)

• Cleaning brushes

• Control unit

Further optional accessories are listed on the Bosch Commercial and

Industrial website.

This symbol is used to point out that the installation and

operating instructions must be read prior to installation

operation or maintenance in order to prevent damage to the

system.

This symbol is used to point out that the

accessories package must be taken out

of the combustion chamber before work

starts.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch Uni Condens 8000 F Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bosch Uni Condens 8000 F

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info