Bedienungsanleitung Bosch UniversalHedgeCut 18 50 (Seite 15 von 236) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch)

777041

Zoom out

Zoom in

Vorherige Seite

1/236

Nächste Seite

English | 15

Sawing Function

Although the tooth opening allows wood to be cut up to Ø

20mm can be cut with the 55 cm blade, the tip of the blade

is designed to cut wood up to Ø 25 mm.

Working with the Hedgecutter (see figure F)

Move the hedgecutter evenly forward along the cutting line.

The double edge cutting blade enables cutting in either dir-

ection, or with a side to side motion.

Cut the sides of the hedge first, then the top.

To cut the sides straightly, we recommend cutting from bot-

tom to top in the direction of growth. Younger stems tend to

move outwards when cutting them from top to bottom, res-

ulting in shallow patches or holes in the hedge.

To reach a level finish, fasten a piece of string along the

length of the hedge at the required height and use as an

alignment guide. Cut the hedge just above the string.

Pay attention that no objects such as wires are cut. The

blade or drive can be damaged.

Anti Blocking

If the blade stalls on a tough material, the load of the motor

increases. The intelligent micro-electronics senses this over-

load condition and repeatedly reverses the motor, in order

to prevent stalling and to cut the branch through.

This audible reversing cut action continues for up to 15

rounds if trigger is pressed.

After cutting through, the garden product continues in its

normal mode, or in case the overload condition continues

the blades automatically stop in the open position (e.g. in

case a piece of metal fence accidentally blocks the garden

product).

Troubleshooting

Hedgecutter

Problem Possible Cause Corrective Action

Hedgecutter does not

operate Battery discharged Recharge battery; also see “Battery Charging”

Battery not fully connected Ensure both locking levels are engaged

Hedgecutter operates

intermittently Internal wiring of garden tool defective Contact Service Agent

On/Off switch defective Contact Service Agent

Motor reverses repeatedly then stops after 3s. see “Working Advice” (Anti Blocking)

Motor runs but blades

remain stationary Internal Error Contact Service Agent

Cutting blade hot Cutting blade blunt Have blade sharpened

Cutting blade has dents Have blade inspected/overhauled

Too much friction, due to lack of lubricant Apply lubricant spray

Blade will not move Battery discharged Recharge battery; also see “Battery Charging”

Machine defective Contact Service Agent

Excessive vibrations/

noise Machine defective Contact Service Agent

Cutting time per bat-

tery charge too low Too much friction, due to lack of lubricant Apply lubricant spray

Blade needs cleaning Clean blade

Poor cutting technique see “Working Advice” (figureF)

Battery not fully charged Recharge battery; also see “Battery Charging”

The blades are running

slow or the anti block-

ing feature is not func-

tioning

Battery discharged Recharge battery; also see “Battery Charging”

Battery stored outside of battery temperature Allow battery to warm naturally to room temperat-

ure (within battery operating temperature 0–

35°C)

Bosch Power Tools F 016 L94 155 | (05.05.2021)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch UniversalHedgeCut 18 50 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bosch UniversalHedgeCut 18 50

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info