Bedienungsanleitung Bosch UniversalVerticut 1100 (Seite 19 von 303) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch)

777044

Zoom out

Zoom in

Vorherige Seite

1/303

Nächste Seite

English | 19

Note: In conditions with excessive tree debris (e.g. leaves,

twigs, etc.), first clear the surface by using the product with

the working height set to 3 or 4.

For best results mow the lawn before reseeding. Promote

the spread of grass into bare and weak areas with good qual-

ity lawn seed after raking/verticutting. Allow fresh grass

seed to root and establish before fertilising, where neces-

sary water to prevent fresh seeds drying out.

Ideal times for raking/verticutting are spring and late au-

tumn.

Lawns can also be maintained by raking/verticutting on a

higher setting after every six cuts.

Troubleshooting

The following chart lists problem symptoms, possible causes and corrective action, if your product does not operate properly.

If these do not identify and correct the problem, contact your service agent.

uWarning: Switch off and remove plug from mains be-

fore investigating fault.

Problem Possible Cause Corrective Measure

Garden tool does not

operate Power turned off Turn power on

Mains socket faulty Use other socket

Extension cable damaged Inspect cable, replace if damaged

Fuse faulty / blown If fuse blows continuously, please check your

electricity supply system or contact Bosch cus-

tomer service agent

Possible clog Check underneath the garden product and clear

out as necessary (always wear protective gloves)

Safety cut out is active (only UniversalVerti-

cut1100) See below A)

Setting for raking/verticutting too low for the con-

ditions Increase working height

Obstructed rotor Clear obstruction (always wear protective gloves)

Blocked side grilles Clear debris from the outside of the side grilles

Grassbox full Empty the grassbox regularly

Garden tool runs inter-

mittently Extension cable damaged Inspect cable, replace if damaged

Internal wiring of garden tool defective Contact Bosch customer service agent

Worn/Missing tines/blades Contact Bosch customer service agent

Conditions too wet Increase working height (see "Tips for Raking/Ver-

ticutting Lawns")

Too much debris on the ground See below A)

Possible clog Check underneath the garden tool and clear out

as necessary (always wear protective gloves)

Setting for raking/verticutting too low for the con-

ditions Increase working height

Grass too long Cut grass

Very uneven surface Increase working height

Grassbox full Empty the grassbox regularly

Garden tool runs stiffly

or belt squeaks Working height too low Increase working height (see "Adjusting the Work-

ing Height")

Cutting tines/blades

not rotating Cutting tines/blades obstructed by grass Clear obstruction (always wear protective gloves)

Belt slipping or damaged Contact Bosch customer service agent

Excessive vibrations/

noise Cutting tines/blades damaged Contact Bosch customer service agent

Poor work perform-

ance Ground too moist for raking/verticutting Increase working height (see "Tips for Raking/Ver-

ticutting Lawns")

Bosch Power Tools F 016 L94 116 | (17.02.2021)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bosch UniversalVerticut 1100 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info