14
en
Minor faults with simple solutions
! Repairs necessary in the electrical appliances will only be able to be performed by electricians or
specialist technicians. Repairs carried out incorrectly may be highly dangerous or seriously harm
the user.
Malfunction
Possible cause / Remedy
The machine's plug is not connected or not properly connected
to the socket. The fuse has blown. Electrical power failure.
In the event of a power failure or appliance malfunction,
emergency draining is possible, so that the laundry can be
removed from the machine; see «Cleaning the drainage pump»
The «Start M» button has not been pressed. The door is not proĆ
perly closed («Ready-Wash» and «Rinse» indicators flash).
This is not a malfunction. There is water in the appliance but it is
beneath the visible area. The electronic control reduces conĆ
sumption mantaining all the features.
Abnormally high degree of soiling. Insufficient detergent. MeasuĆ
re out the detergent in line with the manufacturer's instructions.
Select the most suitable wash programme for the laundry.
Too much detergent has been used. Disconnect the appliance for
5 Ć 10 minutes. To prevent the build-up of foam, put a dessertĆ
spoon of softener mixed with half a litre of water in the detergent
drawer. Reduce the amount of detergent used in your next wash.
Some detergents produce a large quantity of foam although this
has no effect on the rinsing result.
This is not a malfunction. During the heating stage, the motor proĆ
duces noises characteristic of starting.
This is not a malfunction. These noises are characteristic of the
machine starting and the pump discharging.
The transport securing devices have not been removed. Note the
installation instructions. The adjustable feet on the machine were
not fixed during installation. Place the machine and fix the feet acĆ
cording to the installation instructions.
The outlet pump is blocked, see «Cleaning the drainage pump»; the
outlet pipe is bent or blocked («Rinse» and «Spin-End» indicators
flash in both cases).
The safety feature is activated. The option «Rinse hold L» has
been selected.
The tap is turned off. The water inlet filters are dirty («Ready-
Wash» and «Spin-End» indicators flash); see «Cleaning the filters in
the water inlet».
Security protection activated. Close the inlet tap and contact the
After Sales Service.
Motor fault. Contact the After Sales Service.
