Bedienungsanleitung Bosch WAE24063 - Maxx 6 (Seite 2 von 8) (Englisch)

550926

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Overview of programmes a refer to the table of consumption values on page 8 and notes on page 6.

Programmes °C max.

Type of laundry

Additional functions; information

Cottons 20, 30, 40, 60, 90 °C 6 kg

Hard-wearing fabrics, heat-resistant fabrics made of cot-

ton or linen

Rinse Plus, Express Wash

Easy-Care 30, 40 °C

3 kg

Easy-care fabrics made of cotton, linen, synthetic fibres or

blended fabrics

Rinse Plus, Express Wash

Mixed Load 30 °C Fabrics made of cotton or easy-care fabrics

Rinse Plus, Express Wash;

different types of laundry can be washed together

Delicates 30 °C

2 kg

For delicate, washable fabrics, e.g. made of silk, satin,

synthetic fibres or blended fabrics (e.g. curtains)

Rinse Plus, Express Wash;

No spin between rinse cycles

:÷/ Wool 30 °C

Handä or machine-washable fabrics made of wool or con-

taining wool

Particularly gentle wash programme to prevent shrink-

age of laundry. Longer programme breaks (fabrics rest

in the detergent solution)

Additional

programmes

Rinse, Spin, Drain

 Programmes without prewash - add detergent to compartment II, programmes with prewash - distribute the detergent between compartments I and II (model-dependent).

9403 / 9000978497

*978497*

WAE24063GB ...

Robert Bosch Hausgeräte GmbH

Carl-Wery-Str. 34

81739 München / Deutschland

Safety instructions

– Read the instruction manual and installation instructions and all other information enclosed

with the washing machine and act accordingly.

– Retain the documents for subsequent use.

Risk of electric shock – Never pull the cable to disconnect the mains plug.

– Never insert/disconnect the mains plug with damp hands.

Danger to life For worn-out appliances:

– Disconnect the mains plug.

– Sever the mains cable and discard along with the plug.

– Destroy the lock on the washing machine door. This will prevent

children from locking themselves in and risking their lives.

Danger of suffocation – Keep packaging, film and packaging parts out of the reach of

children.

Risk of poisoning – Keep detergents and care products out of the reach of children.

Risk of explosion – Items of laundry pretreated with cleaning agents containing

solvents, e.g. stain remover/cleaning solvent may cause an

explosion after being loaded into the washing machine.

Rinse items of laundry thoroughly by hand beforehand.

Risk of injury – The washing machine door can become very hot.

– Be careful when draining hot detergent solution.

– Do not climb onto the washing machine.

– Do not lean on the open washing machine door.

– Do not reach into the drum if it is still rotating.

– Be careful when opening the detergent drawer while the machine

is in operation.

Consumption values depending on model

Programme Load Electricity** Water**

Programme

duration**

Cottons 20 °C 6 kg 0,33 kWh 62 l 1 B h

Cottons 40 °C 6 kg 0,78 kWh 62 l 2 h

Cottons 60 °C 6 kg 1,22 kWh 62 l 2 @ h

Cottons 90 °C 6 kg 1,94 kWh 65 l 2 @ h

Easy-Care 40 °C 3 kg 0,61 kWh 52 l 1 B h

Mixed Load 30 °C 3 kg 0,27 kWh 60 l 1 h

Delicates 30 °C

2 kg 0,29 kWh 51 l B h

: / Wool 30 °C

2 kg 0,17 kWh 33 l 1 h

Programme Load

Annual energy

consumption

Annual water

consumption

Cottons  / ~* 6 kg 152 kWh 10120 l

* Programme setting for testing and energy labelling in accordance with EU directive 2010/30/EU with cold water

(15 ºC).

** The values deviate from the indicated values depending on water pressure, hardness, and inlet temperature, ambient

temperature, type, amount and soiling of the laundry, detergent used, fluctuations in the power supply and selected

additional functions.

Care

Before washing for the first time

Do not load any laundry into the machine. Turn on the tap.

Add the following to compartment II:

– approx. 1 litre water

– detergent (dosage according to the manufacturer's instructions for light soiling and the

appropriate degree of water hardness)

Set the programme selector to Cottons 60 °C and select Start. At the end of the programme,

turn the programme selector to Off.

Machine housing, control panel

– Wipe with a soft, damp cloth.

– Do not use any abrasive cloths, scourers or cleaning agents (stainless steel cleaners).

– Remove detergent and cleaning agent residue immediately.

– Do not clean with a jet of water.

Cleaning the detergent drawer and housing...

... if it contains detergent or fabric softener residues.

1. Pull the drawer out, press down the insert and fully remove the drawer

from the housing.

2. To remove the insert: press the insert upwards from below with your

finger.

3. Clean the detergent dispenser tray and insert with water and a brush and

dry it. Also remove any detergent or fabric softener residues in the

housing.

4. Attach the insert and engage (connect the cylinder to the guide pin).

5. Push in the detergent drawer.

Leave the detergent drawer open so that any residual water can

evaporate.

Washing drum and rubber seal

Wipe the inside of the rubber seal dry with a cloth. Leave the washing machine door open so

that the drum can dry out. Rust stains - use chlorine-free cleaning agent, not steel wool.

Descaling Ensure there is no laundry in the machine

Descale the appliance according to the descaler manufacturer's instructions. This should not

be necessary if the correct dosage of detergent is used.

Information to indicator lights

Indicator lights for status displays and/or buttons flash:

Indicator lights

Rinse and

Wash flash

Close the washing machine door properly; laundry may be caught.

Indicator lights

Spin and

Wash flash

Open the tap completely, supply hose kinked or trapped;

Clean the filter a page 10, Water pressure too low.

Indicator lights

Spin and

Rinse flash

Detergent solution pump blocked; Clean the detergent solution pump

a page 10.

Drainage hose/waste pipe blocked; Clean the drainage hose at the

siphon a page 10.

Indicator light

Rinse flashes

Motor fault. Call the after-sales service.

All indicator lights flash Turn off the tap and call the after-sales service.

– Risk of electric shock. Disconnect the mains plug.

– Risk of explosion. No solvents.

Maintenance

Detergent solution pump

Turn the programme selector to Off and disconnect the mains plug.

1. Open and remove the service flap.

2. For models with a drainage hose: Remove the drainage hose from the retainer and pull it

from the housing. Remove the container.

Remove the sealing cap, allow the detergent solution to flow out.

Replace the sealing cap and place the drainage hose in the retainer.

2* For models without a drainage hose: Carefully unscrew the pump cover until the

detergent solution begins to flow out. When the service flap is half full, close the pump cover

and empty the service flap. Repeat the above steps until all the detergent solution has

completely drained out.

3. Carefully unscrew the pump cover (residual water).

4. Clean the interior, pump cover thread and pump housing (the impeller in the detergent

solution pump must rotate).

5. Replace the pump cover and screw it tightly in place.

6. Place the service flap back on and close.

To prevent unused detergent from flowing straight into the drain during the next wash: pour 1 litre of water into

compartment II and start the Drain programme.

Drainage hose at the siphon

Turn the programme selector to Off and disconnect the mains plug.

1. Loosen the hose clamp, carefully remove the drainage hose (residual water).

2. Clean the drainage hose and siphon connecting piece.

3. Reattach the drainage hose and secure the connection with the hose clamp.

Filter in the water supply

Reduce the water pressure in the supply hose:

1. Turn off the tap.

2. Select any programme (except for Spin / Drain).

3. Select Start. Let the programme run for approximately 40 seconds.

4. Turn the programme selector to Off. Disconnect the mains plug.

Clean the filter:

1. Depending on model:

Disconnect the hose from the tap.

Clean the filter using a small brush.

and/or for Standard and Aqua-Secure models:

Remove the hose on the rear of the appliance.

Remove the filter with pliers and clean.

2. Connect the hose and check for leaks.

– Risk of scalding.

Allow the detergent solution to cool down.

– Turn off the tap.

What to do if ...

Water is leaking out. – Attach/replace the drainage hose correctly.

– Tighten the screw connection of the supply hose.

No water supply.

Detergent not dispensed.

– Start not selected?

– Tap not turned on?

– Filter blocked? Clean the filter a page 10.

– Supply hose kinked or trapped?

Washing machine door

cannot be opened.

– Safety function active. Wait approx. 2 minutes.

Programme does not

start.

– Start selected?

– Washing machine door closed?

Detergent solution is not

drained.

– Clean the detergent solution pump a page 10.

– Clean the waste pipe and/or drainage hose.

Water not visible in the

drum.

– Not a fault - water below the visible area.

Unsatisfactory spin

result.

Laundry wet/too damp.

– Not a fault - the unbalanced-load detection system has cancelled

the spin cycle because of uneven distribution of the laundry.

Distribute small and large items of laundry evenly inside the

drum.

Spin cycle performed

several times.

– Not a fault - unbalanced load detection system adjusts the

imbalance.

Residual water in the

compartment for care

products.

– Not a fault - the action of the care product is not affected.

– Clean the insert if necessary a page 9.

Odour formation in the

washing machine.

– Run programme Cottons 90 °C without laundry. Use standard

detergent.

Foam escaping from the

detergent drawer.

– Too much detergent used?

If foam is escaping from the detergent drawer:

Mix 1 tablespoon of fabric softener with ½ litre of water and pour

into compartment II (not with outdoor or down fabrics).

– Reduce the detergent dosage for the next wash cycle.

Intense noise formation,

vibrations and “walking”

during the spin cycle.

– Are the appliance feet fixed?

Secure the appliance feet a Installation instructions.

– Transportation safety devices removed?

Remove the transportation safety devices a Installation

instructions.

Noises during spin and

drain cycles.

– Clean detergent-solution pump a page 10.

The indicator lights do

not function during

operation.

– Power cut?

– Fuses tripped? Reset/change the fuse.

– If the fault occurs repeatedly, call the after-sales service.

Programme sequence

longer than usual.

– Not a fault - unbalanced load detection system adjusts

imbalance by repeatedly distributing the laundry.

– Not a fault - foam detection system active - adds an additional

rinse cycle.

Detergent residues on

the laundry.

– Occasionally, phosphate-free detergents contain water-insoluble

residues.

– Select Rinse or brush out the laundry after washing.

If you cannot correct a fault yourself (switching on/off) or a repair is required:

– Turn the programme selector to Off and remove the mains plug from the socket.

– Turn off the water supply and call the after-sales service a Installation instructions.

en operating instructions

Washing machine

WAE24063GB ...

Bosch WAE24063 - Maxx 6 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info