600511
39
Zoom out
Zoom in
Vorherige Seite
1/52
Nächste Seite
Faults and what to do about them. en
39
The programme is taking
longer than usual.
Not a fault – the unbalanced load detection system is adjusting an
imbalance by repeatedly distributing the laundry.
Not a fault – the foam detection is system active – a rinse cycle has been
switched on.
The length of the
programme changes
during the wash cycle.
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown in the display
panel.
Residual water in the
care-product
compartment v u.
Not a fault – the effect of the care product is not affected.
Odours in the washing
machine.
Run the Drum Clean or Cottons 90 °C programme without laundry.
Add washing powder or a detergent containing bleach.
Note: . To prevent foaming, only use half the amount of detergent
recommended by the detergent manufacturer. Do not use detergent designed
for woollens or delicates.
The Å symbol lights up
in the display panel. Foam
may also be leaking from
the detergent drawer.
Have you used too much detergent?
Mix one tablespoon of fabric softener with 1/2 litre of water and pour it into
compartment v u (not suitable for outdoor clothing, sportswear or items
stuffed with down).
Use less detergent in the next washing cycle.
Repeated, intensive
foaming.
Check your basic dosage and dosage strength settings.
If required, use a different liquid detergent.
Detergent/fabric softener
drips off the seal and
collects on the door or in
the seal fold.
There is too much detergent/fabric softener in the dispensers. Do not fill above
the max. mark in the dispensers.
Loud noises, vibrations
and machine "movement"
during the spin cycle.
Is the appliance aligned? Align the appliance. ~ Page 47
Are the appliance's feet fixed? Secure the appliance's feet. ~ Page 47
Have the transport braces been removed? Remove the transport braces.
~ Page 44
The display panel/
indicator lights do not
work while the appliance
is running.
Has there been a power failure?
Have the fuses blown? Reset/replace the fuses.
If the fault occurs repeatedly, call customer services.
There is detergent
residue on the laundry.
Some phosphate-free detergents contain water-insoluble residue.
Select Rinse or brush the laundry after washing.
- P - appears in the
display panel when the
cycle is paused.
The water level is too high. It is not possible to add laundry. Close the door
immediately, if necessary.
Press the A button to continue the programme.
Faults Cause/Remedy
39

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

bosch-waw28640

Suche zurücksetzen

  • Es erscheint E 81 mit Signalton.
    In meiner Betriebsanleitung gebt es dazu keinen Hinweis. Eingereicht am 28-4-2024 08:31

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bosch WAW28640 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Bosch WAW28640

Bosch WAW28640 Bedienungsanleitung - Deutsch - 56 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info