8
Installation
Scope of delivery: dryer, installation and operating instructions.
Check dryer for transport damage.
The dryer is very heavy. Do not attempt to lift it on your own.
Be careful to avoid sharp edges.
Do not set up in a room that is susceptible to frost. Freezing water may cause damage.
If in doubt, have the appliance connected by a specialist.
Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
Setting up the dryer
The appliance plug must always be accessible.
Ensure that the appliance is installed on a clean, level
and firm surface.
Do not obstruct the air inlet on the front of the dryer.
Keep the area around the dryer clean.
Make the dryer level using the threaded feet
and a spirit level.
Do not remove the threaded feet under any
circumstances.
Mains connection see Safety instructions apage 13.
Connect to an AC earthed socket. If in doubt have the
socket checked by a specialist.
The mains voltage and the voltage shown on the rating
plate (apage 10) must be the same.
The connected load and necessary fuse protection are
specified on the rating plate.
Frost protection / Transport
Frost protection - preparation
1. Empty the condensation container apage 4.
2. Select any programme using the programme selector.
3. Press the Start/Stop button a condensed water is pumped into
the container
4. Wait 5 minutes and then empty the condensation container again.
5. Turn the programme selector to Off.
Transport
Prepare the dryer a see Frost protection - preparation.
Transport the dryer in a vertical upright position.
Following transportation, do not use the dryer for two hours.
The dryer contains residual water;
this can flow out if the dryer is tilted.
Signal
Switching on/off an acoustic signal at the end of the programme
Low Heat Ď light on a"an acoustic signal at the end of the programme is switched on.
Low Heat Ď light off a an acoustic signal at the end of the programme is switched off.
9
Care and cleaning
Heat exchanger
The dryer's heat exchanger is cleaned automatically during drying.
Do not pull out the condensation container during the cleaning process.
Dryer housing, control panel, air intake
Wipe with a soft, damp cloth.
Do not use harsh cleaning agents or solvents.
Remove detergent and cleaning agent residue immediately.
Filter in the condensation container
The filter is cleaned automatically when the condensation container is emptied.
However, the filter should still be cleaned regularly under running water a This prevents
stubborn deposits/dirt from building up.
1. Pull out the condensation container.
2. Pull the filter out of its snap-in lock.
3. Clean the filter under running water or in the dishwasher.
4. Refit the filter.
5. Insert the condensation container so that it locks into place.
Only operate the dryer with the filter inserted.
Moisture sensor
The dryer is equipped with stainless steel moisture sensors. Moisture sensors measure how
damp the laundry is. A thin layer of limescale may build up on the moisture sensors after
prolonged use.
1. Open the door.
2. Clean the moisture sensors using a damp sponge with a rough surface.
Do not use steel wool or abrasive materials.
Appliance must be switched off.
