PACKLITE
TM
POWER AMPLIFIER MODEL A1
8
EnglishDeutschFrançais DanskEspañolItalianoSvenska Nederlands
Figure 4
Typical setup
B1 bass
modules
B1 bass
modules
PS1 power stand
Bass-Line
OUT
INPUT
OUTPUT
A1 amplifier
CAUTION: Do not connect more than two B1 bass modules to an
A1 amplifier.
CAUTION: Be careful not to connect the A1 amplifier to a B1 bass
module that is already connected to the Amp 3 OUT connector of
a PS1 power stand, or to another A1 amplifier.
Note: Using the supplied ¼" TRS cable with your A1 amplifier is
recommended. Using balanced cabling prevents common
interconnect noise problems.
Note: Up to four (maximum) B1 bass modules can be
stacked in a column. Stacking may improve acoustic output.
Using multiple A1 amplifiers together
To add more bass capability to your system, you can connect
multiple A1 amplifiers as shown in Figure 5 on page 9.
1. Connect the AC power cord to an AC (mains) outlet.
2. Make sure the Power switch is OFF.
3. Using the supplied ¼" TRS cable, connect the Bass-Line
OUT connector on the PS1 power stand to the INPUT
connector on the first A1 amplifier.
