17
Figure 20
28
27
A
Main
Assembly
Step 20 - Attach the Faceplate Back Panels
Locate the following items:
• Item #27 - Faceplate Right Back Panels
• Item #28 - Faceplate Left Back Panels
• From Step 19 - Main Assembly
• Item #A - (2) #10 Phillips Head Screws
Slide each Faceplate Back Panel (Items #27 & 28), textured
side out, against the textured (back) side of the Faceplate.
The screw heads of the (2) Phillips Head Screws installed
during Step 19 should allow the Back Panels to slide
beneath them until the panels meet in the center..
Secure the Panels using (2) #10 Phillips Head Screws (Item
#A), as shown in Figure 20, attaching one side at a time.
Completely tighten hardware installed during Steps 19 & 20.
Step 21 - Tighten Lower Bolt on the Seat Bracket
Locate the following items:
• From Step 5 - Seat Assembly (underneath)
Using an Allen Wrench (included) and a combination wrench,
tighten the top nut & bolt on the Seat Assembly (see Figure
21). Take care that the Seat Assembly can still freely slide
without resistance along the Seat Rail when you are seated.
Note: The Seat Assembly will have some resistance when
rolling if no one is seated.
Take care not to overtighten hardware from Step 21.
Figure 21
Nut
Assembly Guide
