38
5/ DETERGENT PRODUCTS AND SETTING THE WATER SOFTENER
EN
• FOR TRADITIONAL PRODUCTS
Important:
It is very important to set your water softener correctly.
- If the setting is too low, there is a risk of chalky marks
- If the setting is too high, there is the risk of the glasses becoming cloudy
If you move house, re-adjust the setting on your water softener.
• Traditional tablets
Place tablets that are not multi-purpose in the external compartment (Fig 04)
or, for optimum operation, pull out the distributor’s drawer and lay the tablet there. (Fig 05)
• Powder or liquid in the distributor’s drawer (Fig 03)
Fill at least up to the minimum mark for slightly dirty crockery and up to the maximum mark for dirty
crockery. If the crockery is very dirty or for programmes with pre-wash, we recommend that you
add 5g of detergent (a dessertspoonful) to the tub in accordance with the programmes table.
Important:
Keep these products in a dry place, out of children’s reach.
Only use products specially designed for dishwashers.
•
Your appliance must be specially set to use traditional products
.
Fig. 04 Fig. 05Fig. 03
Factory setting: H4.
TTeessttiinngg ssttrriipp
HHaarrddnneessss
0-10°F 10-18°F 18-25°F
25-40°F
40-55°F 55-70°F > 70°F
0-1mmol/l 1-1.8 mmol/l
1.8-2.5 mmol/l
2.5-4 mmol/l
4-5.5 mmol/l 5.5-7 mmol/l
> 7
mmol/l
TTrraaddiittiioonnaall
pprroodduucctt
HIH0 H2 H3 H4 H5 H6
• Proceed as follows to adjust the water softener on the control panel:
—
Go to the “Set” position by pressing the programme button
. The corresponding light comes on.
The screen displays
SET
to indicate that you are in setting mode.
— Press the “Delayed start” button The screen displays the set-
ting
HH44
factory setting).
— To modify this setting (depending on water hardness), press
either programme button .
— To modify this setting (depending on water hardness), press
either programme button several times. Each press changes the setting.
Refer to the table below.— Confirm by pressing “Start / C.”.
Start / C.
