Bedienungsanleitung Braun 5020s (Seite 11 von 70) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

514819

Zoom out

Zoom in

Vorherige Seite

1/70

Nächste Seite

Model 5040s w&d only:

This appliance is suitable for use in a bath or

shower. For safety reasons this appliance

can only be operated cordlessly.

MultiHeadLock switch (head lock)

To shave hard-to-reach areas (e.g. under the nose)

slide the MultiHeadLock switch (3) down to lock the

shaver head. The shaver head can be locked in five

positions. To change position, move the shaver head

with your thumb and forefinger back or forth. It will

automatically click into the next position.

To set it back into the pivoting position the

MultiHeadLock switch needs to be slid up again.

Models 5090cc/5070cc/5050cc: For automatic

cleaning in the Clean&Charge Station the head lock

should be released.

Long hair trimmer

To trim sideburns, moustache or beard press the

release button (8a) and slide the long hair trimmer

(6) upwards.

Shaving with the cord (models 5090cc/5070cc/

5050cc/5030s/5020s only)

If the shaver has run out of power (discharged), you

may also shave with the shaver connected to an

electrical outlet via the special cord set.

Travel lock

• Activation: By pressing the on/off switch (4) for

3 seconds the shaver is locked. This is confirmed

by a beep sound and the lock symbol

in the

display. Afterwards the display turns off.

• Deactivation: By pressing the on/off switch for

3 seconds the shaver is unlocked again.

Manual cleaning of the shaver (s. fig. B/C)

The shaver is suitable for cleaning under

running tab water. Warning: Detach the

shaver from the power supply before

cleaning it in water.

• Switch the shaver on (cordless) and rinse the

shaver head under hot running water. You may use

liquid soap without abrasive substances.

Rinse off all foam and let the shaver run for a few

more seconds.

• Next, switch off the shaver, press the release

button (2) to remove the Foil & Cutter cassette (1)

and let it dry.

• If you regularly clean the shaver under water, then

once a week apply a drop of light machine oil on

top of the Foil & Cutter cassette.

Alternatively, you may clean the shaver using the

brush provided:

• Switch off the shaver. Remove the Foil & Cutter

cassette (1) and tap it out on a flat surface. Using

the brush, clean the inner area of the pivoting

head. Do not clean the cassette with the brush as

this may damage it!

Model 5040s only – foam usage:

After each foam use release the shaver head and

rinse all parts for 30 seconds under warm water.

Clean&Charge Station

for models 5090cc/5070cc/5050cc only

The Clean&Charge Station has been developed for

cleaning, charging, lubricating, disinfecting and

storing your Braun shaver.

12 Station power socket

13 Lift button for cartridge exchange

14 Station-to-shaver contacts

15 Clean&Charge Station display

15a Status light

16 Start button

17 Cleaning cartridge

Installing the Clean&Charge Station (see fig. D)

• Remove the protection foil from the Clean&Charge

Station display.

• Using the special cord set (10), connect the

station power socket (12) to an electrical outlet.

• Press the lift button (13) at the rear side of the

Clean&Charge Station to lift up the housing.

• Hold the cleaning cartridge (17) down on a flat,

stable surface (e.g. table).

• Carefully remove the lid from the cartridge.

• Slide the cartridge from the rear side into the base

of the station until it snaps into place.

• Slowly close the housing by pushing it down until

it locks.

Charging the shaver in the Clean&Charge Station

(see fig. D)

Insert the shaver head down into the cleaning station.

Important: The shaver needs to be dry and free

from any foam or soap residue!

The contacts (7) on the back of the shaver need to

align with the contacts (14) in the station. Push the

shaver in the correct position.

A beep sound confirms that the shaver sits properly

in the station. Charging will start automatically.

Model 5090cc: The Clean&Charge Station analyzes

the hygiene status. The status is shown by the

cleaning program indicators

in the Clean&Charge

Station display (15) more details see chapter

«Cleaning programs» below.

Cleaning the shaver (see fig. D)

When the cleaning indicator lights up in the shaver

display, insert the shaver into the Clean&Charge

Station, upside down and with the front showing (with

released head lock/contact alignment/beep sound).

95785608_5090cc_MN_S6-66.indd 11 03.04.12 15:13

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Braun 5020s Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info