Bedienungsanleitung Braun 5411 - 390cc-4 - Boss limited edition (Seite 13 von 68) (Alle Sprachen)

695247

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

After you have replaced the Foil & Cutter

cassette (1), press the on/off switch (4) for

at least 5 seconds to reset the counter.

While doing so, the replacement light

blinks and goes off when the reset is

complete. The manual reset can be done

at any time.

Preserving the batteries

In order to maintain the optimum capacity

of the rechargeable batteries, the shaver

has to be fully discharged (by shaving)

every 6 months approximately. Then

recharge the shaver to full capacity.

Environmental notice

This product contains rechargeable

batteries. In the interest of

protecting the environment, please

do not dispose of the product in

the household waste at the end of its

useful life. Disposal can take place at a

Braun Service Centre or at appropriate

collection sites provided in your country.

C Clean&Renew

Braun Clean&Renew has been developed

for cleaning, charging and storing your

shaver.

Clean your shaver daily in the

Clean&Renew.

During the automated cleaning process,

the shaver is switched on and off at

intervals to obtain best cleaning results.

Since the specially formulated cleaning

fluid contains a small amount of oil,

the cleaning procedure also fulfils the

lubrication needs of the shaver.

Important

• Only use the power supply cord set

supplied with the shaver.

• In order to avoid any leakage of the

cleaning fluid, place the appliance on a

flat, stable surface. Do not tip, move

suddenly or transport in any way if a

cleaning cartridge is installed.

• Do not place the appliance in a mirror

cabinet, nor store it over radiators, nor

place it on polished or lacquered sur-

faces. Do not expose to direct sunlight.

• The appliance contains highly flam-

mable liquid. Keep it away from sources

of ignition. No smoking.

• Keep out of reach of children. Do not

refill cartridge. Use only original Braun

refill cartridge.

Description

1 Start/release button

2 Contact bow

3 Lift button for cartridge exchange

4 Level indicator

5 Cleaning cartridge

Before using Clean&Renew

Installing the cartridge

• Press the lift button (3) to open the

housing.

• Hold the cartridge down on a flat,

stable surface (e.g. table). Carefully

remove the lid from the cartridge. Slide

the cartridge into the base as far as it

will go.

• Slowly close the housing by pushing it

down until it locks.

Replacing the cartridge

After having pressed the lift button to

open the housing, wait for a few seconds

before removing the used cartridge.

Before discarding the used cartridge,

make sure to close the openings using

the lid of the new cartridge, since the

used cartridge will contain contaminated

cleaning solution.

The used cartridge can be disposed of in

the household waste.

Operating your

Clean&Renew

• Connect your Clean&Renew with the

cord set (10) to the mains electricity

supply. The special socket at the back

is adjustable to save space. After each

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Braun 5411 - 390cc-4 - Boss limited edition Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info