Bedienungsanleitung Braun 5885 contour (Seite 6 von 18) (Englisch, Französisch, Spanisch)

369501

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

Description

1 Shaver foil

2 Cutter block

3 Release button

4 On/off switch («start/stop»)

5 Long hair trimmer

6 Charging lights (green)

7 Low-charge light (red)

8 Replacement light for shaving parts

9 Reset button

10 Special cord set

Charging

The best environmental temperature for

charging is between 60 °F to 95 °F/15 °C and

35 °C.

• Using the special cord set, connect the

shaver/charging stand to an electrical outlet

with the motor switched off.

• When charging for the first time, leave the

shaver to charge continuously for 4 hours.

• Once the shaver is completely charged,

discharge the shaver through normal use.

Then recharge to full capacity. Subsequent

charges will take about 1 hour.

• A full charge provides up to 50 minutes of

cordless shaving time depending on your

beard growth.

• Maximum battery capacity will only be

reached after several charging/discharging

cycles.

• If the rechargeable batteries are discharged,

you may also shave by connecting the

shaver to an electrical outlet via the special

cord set.

Charging lights

The 3 charging lights (6) blink to indicate the

charging level by thirds. When fully charged,

all 3 charging lights shine permanently.

Low-charge light

The red low-charge light flashes when the

battery capacity has dropped below 20%,

provided the shaver is switched on.

The re-maining capacity will then be sufficient

for 2 to 3 shaves.

Shaving

Turn on the shaver («start»):

The pivoting cutting system automatically

adjusts to every contour of your face.

Trimmer:

When the long hair trimmer is activated, it allows

the controlled trimming of moustache or

sideburns.

Cleaning

The hand-held unit should be detached from

the power supply cord before cleaning. The

shaver should not be used until it has dried.

Regular cleaning ensures better shaving

performance. Rinsing the shaving head after

each shave under running water is an easy and

fast way to keep it clean:

• Switch the shaver on (cordless) and rinse

the shaving head under hot running water.

A natural based soap may also be used

provided it contains no particles or abrasive

substances. Rinse off all foam and let the

shaver run for a few more seconds.

• Next, switch off the shaver, remove the

shaver foil and the cutter block. Then leave

the disassembled shaving parts to dry.

Tips for the perfect shave

• It can take up to 14-21 days for your beard

to adjust to the new shaving system.

• Shave before washing your face or taking

a shower, as skin tends to swell after

washing.

• The drier the skin, the closer the shaving

results will be.

• Hold the shaver at right angles (90°) to the

skin. Stretch the skin and shave against

the direction of beard growth.

• To maintain 100% shaving performance,

replace the shaver foil and cutter block,

when the replacement light (8) comes on

(after about 18 months), or when the

shaving parts are worn.

5737450_Contour_5885_NA Seite 6 Donnerstag, 1. März 2007 2:36 14

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Braun 5885 contour Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info