Bedienungsanleitung Braun BUA5000 - ExactFit 1 (Seite 4 von 70) (Deutsch, Englisch, Französisch, Spanisch, Polnisch, Türkisch)

695181

Zoom out

Zoom in

Vorherige Seite

1/70

Nächste Seite

Key rules for accurate blood pressure measurement

• Always take readings at the same time of day, ideally in the morning,

under the same conditions.

• Do not measure within 30 minutes after smoking, coﬀee or tea

consumption or any form of exertion. These factors will inﬂuence the

measurement results.

• Always measure on the same upper arm.

• Take oﬀ wrist watch and jewelry before ﬁtting the cuﬀ on the

measuring arm.

• Wait approximately 3 minutes before repeating a measurement.

• Do not wrap the cuﬀ over a jacket or sweater. This will aﬀect the

measurement.

• Remove tight-ﬁtting clothing from your arm.

Applying the arm cuff

Pile side material

Velcro

Smooth

cloth

Metal ring

Fig. 1 Fig. 2 Fig. 3

Main

arteries

1. Plug the air hose into the connector (Fig. 1).

2. The cuﬀ is located correctly when the velcro is on the outside of the

cuﬀ and the metal ring does not touch the skin (Fig. 2).

3. Put your arm through the cuﬀ loop. The bottom of the cuﬀ should be

approximately 2-3 cm above elbow. The tube should lie over the

brachial artery on the inside of the arm (Fig. 3).

Adult cuﬀ

22-42 cm

Fig. 4 Fig. 5 Fig. 6

4. Pull the cuﬀ so that the top and bottom edges are tightened around

your arm (Fig. 4).

5. When the cuﬀ is positioned properly, press the Velcro ﬁrmly against

the pile side of the cuﬀ.

6. This cuﬀ is suitable for use if the arrow heads fall within the stripe

pattern on the other side of the cuﬀ when the cuﬀ is tightened

around your arm (Fig. 5).

7. Sit on a chair and place your arm on the table so that the cuﬀ is at the

same level as your heart (Fig. 6).

Taking a measurement

8. Sit on a chair with your feet ﬂat on the ﬂoor.

9. Wrap the cuﬀ snugly around your arm

(see “Applying the arm cuﬀ” section above,

Fig. 3-6).

10. Do not move the unit during measurement,

or the proper measurement will not be

achieved.

11. Press power button

to begin. The measurement starts

automatically. While measurement is in progress, do not move or

speak.

Note: If necessary to interrupt a measurement, press the power

button

at any time. The device immediately cancels the

measurement, lowers cuﬀ pressure and automatically turns oﬀ.

12. The cuﬀ will ﬁrst inﬂate and then deﬂate. At the end of the

measurement there are 2 ﬁnal beep sounds and the reading is

displayed:

Upper (systolic) value

Lower (diastolic) value

Pulse

13. Press the power button

to turn the product oﬀ. Otherwise the

product will turn oﬀ automatically after 1 minute. If at any time you

want to stop the measurement, press the power button

14. Test results will be saved into the memory automatically ( see

memory function below).

English

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Braun BUA5000 - ExactFit 1 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Braun BUA5000 - ExactFit 1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info