Bedienungsanleitung Braun oral b d 5011 (Seite 2 von 6) (Deutsch, Englisch)

401893

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

switch the power unit on after

guiding the brushhead to your teeth.

Then, move the brushhead along

the chewing surfaces of your teeth.

After that, hold the brushhead at a

90° angle and guide it along the

outsides and then the insides of

your teeth. Be sure to get into the

spaces between your teeth as well

as along the gumline. The Braun

Oral-B Plak Remover will auto-

matically provide the right cleaning

action. You do not need to press

hard. To thoroughly remove plaque,

brush for at least 2 minutes.

After cleaning your teeth, rinse your

mouth thoroughly again. During the

first few days of using the Braun

Oral-B Plaque Remover, your gums

may bleed slightly, particularly if

they normally tend to do so. After a

few days, the bleeding will ge-

nerally stop. If your gums continue

to bleed after 2 weeks, you should

see your dentist.

The brushes have soft, end-

rounded bristles in order to protect

your gums. Clinical tests have

shown that the best cleaning effect

is achieved by gently moving the

brush from tooth to tooth, without

exerting pressure. A change in the

shape of the brush is normal after

use. This is influenced by your

individual cleaning technique, but

does not affect the efficiency of th

brush.

INDICATOR brushheads

The INDIDCATOR brushhead (e / l)

helps you monitor your brushing

performance.

Dentists recommend that you

replace any toothbrush every 3 to 4

months, since worn bristles do not

clean plaque away as effectively as

new ones. With proper brushing,

twice a day for two minutes, the

green colour will wear half-way

down the bristles in this 3 to 4 month

period, provided you use toothpaste

(e / II).

If the bristles begin to splay before

the green colour starts to recede it

means that you are exerting too

much pressure on your teeth and

gums, and wearing out the brush-

head too quickly (e / III).

The INDICATOR brushhead helps

to improve your brushing per-

formance, thus optimizing excep-

tional plaque removal and the life of

the brushhead.

Replacement brushheads are

available at your dealer or Braun

Service Centres.

Cleaning

To maintain the function of the

brushhead

rinse thoroughly for

several seconds with the power unit

switched on under running water

(not warmer than 80 °C) after use

(c).

Clean the brushheads and the

power unit by simply holding them

under running water (d). Wipe the

power unit dry. After cleaning place

the power unit

back on the

charging base

. The green charge

indicator

will light up at 220-240

volts.

Please, also see the insert «Cell

disposal at the end of the useful life

of the appliance».

Wall fastening

Fasten wall plugs and screws in the

wall. However, turn screws into wall

plugs only so far that screw heads

can be stuck into the two openings

in the back of the charging unit

. By pulling the charging unit

down, the screws will be fastened in

the two slits over the screw

openings

You have to pull out only as much

cord from the cord storage as you

need to the mains plug.

Connecting

The charging unit

can be

connected to any voltage outlet –

even to shaver sockets – between

220 - 240 volts ac (~) without

converting. Place the power unit

facing the front, on the charging

base

The green charge indicator

will

light up at 220 -240 volts, whenever

the power unit is inserted and

recharging on the plugged-in

charging unit. The power unit may

warm up somewhat. This has no

significance on the unit’s operation.

Over-charging is impossible. To

maintain your plaque remover’s full

power capacity, the power unit

should always be stored in the

plugged-in charging unit after use.

portant: The power unit

switches off automatically when

placed in the carging unit

permit recharging. Make sure that

there is electrical power in the

socket when you recharge your

power unit. Sockets in mirror

cabinets over wash basins or

shaver sockets in bathrooms may

be without electrical power when

the light is turned off.

Switch

The power unit

is switched on

and off by pressing the circular

marking on the blue switch

(b).

When placed in the charging unit,

the power unit is automatically

switched off. The blue switch is

waterproof and can be cleaned

under running water.

Preserving the rechargeable

batteries

To maximize the capacity and life of

the rechargeable batteries, they

should be fully charged (for 16

hours on 220 - 240 volts) before the

first use and then fully discharged

by using. Then recharge to full

capacity again. This discharging/

charging procedure should be done

every six months.

Use

After the power unit has been fully

charged, attach one of the brush-

head

to the power unit (a). Before

doing so, you may fix one of the

coloured rings

onto the end of the

brushhead. The brushhead must

face the same direction as the

switch

. The roll-stop

prevents

the power unit

from rolling off a

flat surface.

Before brushing your theeth, rinse

your mouse thoroughly and wet the

brushhead. You may use regular

toothpaste. To avoid splashing,

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Braun oral b d 5011 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info