Bedienungsanleitung Braun pv 1505 saphir (Seite 3 von 4) (Englisch)

321955

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

Praktical Guidelines

Type of Water to be Used

This iron is designed for tap water. However, if

you have hard water we recommend to use:

– filtered water (household water filters that also

de-mineralize water are commercially

available) or

– a mixture of 1/2 part tap water and 1/2 part

distilled water from drug stores or grocery

stores.

portant: Never use distilled water (battery

water). Do not add any additives (e. g. starch) to

the water.

To fill iron

1. Pull the plug out of the wall outlet.

2. Put the steam regulator

in position «

•

(= steam off).

3. Open sliding shutter

4. Place the iron in the upright position and fill

with water slowly through the tank opening

to the «max.» marking

(a), using the

beaker

5. Close sliding shutter.

Selecting the temperature

Connect the iron to a safely located wall outlet

and select the ironing temperature with the

temperature selector

(b). As soon as the pilot

light

goes out, the iron has reached the

temperature selected. To avoid water dripping,

always rest the iron upright while heating it up

keep the steam regulator

in position «

•

(= steam off) (c).

You will usually find the following symbols in your

garments:

The temperature selector

is marked with

these symbols:

min. The iron is connected

●

Synthetics (acrylic, acetate)

●●

Silk/rayon/nylon/polyester/

cotton blends/wool

●●●

Cotton/linen

max. Linen

Select the temperature you need according to

these symbols.

Spray, shot of steam, jet of steam

Before you start ironing, we recommend to press

the buttons 3 or 4 times, in order to activate

these functions.

Dry ironing

Set the steam regulator

in position «

•

(= steam off) (c) for dry ironing. The water

spray

may be used at any temperature

setting to dampen the laundry. The jet of steam

and the shot of steam

buttons can be

activated during dry ironing, provided that the

temperature selector

is within the continuous

red area

Steam ironing

(see «Table of features»)

Tem

perature selection: Set the temperature

selector

within the red

range steam (b) and wait

until the iron has reached the selected

temperature (i. e. the pilot light

goes off).

Steam ironing is possible in the entire red range.

Steam ironing at lower temperatures may cause

water drops instead of steam. Should this

happen, turn the steam regulator

to the

position «

•

» (= steam off) (c).

Steam regulator

Select the quantity of

steam required (c) for

each garment with the

steam regulator

You can increase the

quantity by turning the

steam regulator clock-

wise (wide markings) to the end of the red

marking.

Caution: While ironin

g do not turn the steam

regulator further, otherwise hot water may

come out from the sole plate (see section

«Decalcifying/Self-cleaning»).

By turning the steam regulator anti-clockwise

you can reduce the quantity of steam or turn the

steam off «

•

» (= steam off) (see «Ironing

Guide»).

Constant steam

: Your Braun steam iron is

equipped with a special tank configuration to

provide constant steam even when the water

level in the tank is low.

«Extra steam

»*

(coming from the

steam vents in the sole

plate): For stubborn

creases and wrinkles,

collars and cuffs.

When ironing within

the red range

area the extra steam function can

be used. You can press the button

(d) for 3

seconds at intervals of no less than 7 seconds.

Jet of steam*

(coming from the outlets

at the slim pointed tip)

): Caution: Keep chil-

dren away from the jet of

steam and do not hold

your fingers in front of the

outlets

when activating

this function.

When ironing within the red range

area the jet of steam function

can be used (e). To do so, press the button

intervals of no less than 5 seconds. The jet of

steam has been designed not only for steaming

hard to reach areas like pleats, inside of pockets

etc., but also for steaming hanging clothing (e. g.

velvet skirts, curtains, etc.) (g). The jet of steam

functions between horizontal and upright

positions. Be careful not to touch sensitive

textiles with the hot sole plate.

Shot of steam

* (coming

from the vents in the sole

plate): When ironing

within the red

area the shot of

steam function can be

used. It gives an extra,

particular-ly powerful shot

of steam penetrating deep into the textiles in

order to straighten creases, collars and pleats.

The function «shot of steam» can be used in

normal ironing and also vertically for steaming

hanging clothing (e. g. velvet skirts, curtains etc.)

(g). Press the shot of steam button

at intervals

of no less than 5 seconds. When steaming be

careful not to touch sensitive textiles with the hot

sole plate.

* If pressed too frequently, it can drip. Should this

happen, wait a few seconds before using it

again.

Spray

(coming from the

nozzle

): The spray

function can be used at

any temperature, to

dampen laundry. To do

so, press the button

(water spray = blue).

Spray / shot of steam

2-function button:

With the models 4684 and

4687 the functions «water

spray» and «shot of

steam» can be activated

with a 2-function button.

The desired function can

be selected by turning the

button

as far as it will

go. The marking (blue =

water spray or red = shot

of steam) must point to

the respective function (f).

Turn the button from blue

(spray) to red (shot of

steam) anti-clockwise

and from red to blue clockwise (f).

Storage

After ironing, always pull the plug out of the wall

outlet. Set the temperature selector

to «min.»

(b) and the steam regulator

to «

•

» (= steam

off) (c).

To empty the iron hold it with the open water tank

opening

downwards (h) and shake it 1 or 2

times. The swivel cord

conveniently winds up

around the cord storage

IMPORTANT

: Store the cool steam iron in a dry

place and always standing on its heel rest

The sole plate may be damaged by remaining

water if it is stored horizontally. The warranty

does not cover faults or damage resulting from

improper storage of the iron.

Maintenance and Cleaning

To remove residues of minerals/starch from the

sole plate always use steel wool. Never use a

scouring pad, vinegar or other chemicals. The

steam vents

and jet of steam outlets

may

be cleaned manually with a toothpick, if

necessary. Clean the sole plate regularly if you

use starch or other aids on the clothes for

ironing.

Decalcifying / Self-cleaning

Braun irons Saphir-jet have a built-in system

(anti-calc. valve) to prevent calcification. It allows

you to clean residues from the steam chamber.

Do not use commercial decalcifiers; they may

damage the sole plate. We recommend to use

the self-cleaning function every 3 months.

Braun pv 1505 saphir Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Braun pv 1505 saphir

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info