Bedienungsanleitung Braun ThermoScan 5 - IRT3030 (Seite 6 von 60) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

672109

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

8 9

Situation Solution

Ambient

temperature is not

within the allowed

operating range

(10–40 °C or

50–104 °F).

Allow the thermometer to remain

for 30 minutes in a room where

the temperature is between

10 and 40 °C or 50 and 104 °F.

HI = too high

LO = too low

Temperature taken

is not within typical

human temperature

range (34–42.2 °C or

93.2–108 °F)

Make sure the probe tip and lens

are clean and a new, clean,

disposable lens lter is attached.

Make sure the thermometer is

properly inserted. Then, take a

new temperature.

System error Reset the thermometer

by removing the battery and then

replacing it again, wait 1 minute,

then turn on again.

Please contact your authorized

Service Center (See Guarantee

Card).

Battery is low. Insert new battery.

Battery is too low.

Device cannot be

powered on to the

ready state.

Insert new battery.

Do you have any further

questions?

Please contact your authorized

Service Center (See Guarantee

Card).

Changing the temperature scale

Make sure the thermometer is turned o. Press

and hold down the <<start>> button. Keep

holding down the <<start>> button and after

about 3 seconds the display will start to cycle

between temperature scales (°C or °F).

Release the start button when the desired scale

is shown. This will reset the thermometer to the

new temperature scale.

Replacing the battery

The thermometer is supplied with one 3V Lithium cell battery

(type 2032). Insert new battery when the low battery symbol

appears on the display.

The battery door design is

intended to prevent a small

child from easily opening the

battery door to address a

possible choke hazard. Open

the battery compartment by

inserting a narrow pointed object such as a ball point pen or

paperclip into the small hole above the battery door (8). While

pressing into the hole slowly slide back the battery door with

the other hand.

To close battery door align the tabs along the side of the

battery into the battery compartment and slowly slide back

into position until the door clicks into its locked position.

Calibration

This product has been calibrated at the time of manufacture.

If used according to the use instructions, periodic calibration is

not required. If at any time, you question the measuring accuracy,

please contact our service representative (see last page for

contact information) or visit www.hot-europe.com/support.

Manufacturing date is given by the LOT number located in the

battery compartment.

The rst three (3) digits after LOT represent the Julian date that

the product was manufactured and the next two (2) digits

represent the last two numbers of the calendar year the

product was manufactured. The last identiers are the letters

that represent the manufacturer.

An example: LOT 11614fam, this product has been

manufactured on the 116th day of the year 2014.

English

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Braun ThermoScan 5 - IRT3030 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info