Bedienungsanleitung Braun TS 725A (Seite 10 von 80) (Alle Sprachen)

600037

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

• Holding the iron slightly inclined (as

shown in B), ﬁ ll the water tank up to the

«max» marking.

• Place the iron upright on its heel rest and

connect it to the mains.

Select the temperature according to the

ironing guide on the heel rest of the iron or

on the label in your garments.

The pilot light (8) goes off when the

desired temperature is reached (after

approx. 1 1/2 min.).

C Ironing

Vario steam

You can select the steam quantity by

turning the steam regulator (6) in a range

from «0» to «6».

The temperature selector has a minimum

temperature level 2 (••).

We recommend a medium steam setting

for all normal ironing. Only when ironing

linen, thick cotton or similar fabrics we

recommend the maximum steam setting.

Notice: While ironing, do not turn the

steam regulator beyond setting «6».

Vario plus steam

For extra steam, press the steam regulator

(6) for max. 30 seconds.

The temperature selector has a minimum

temperature level 3 (•••).

Precision Shot

Prior to use, press the Precision Shot

button (4) 3 to 4 times to activate it.

Press the Precision Shot button in inter-

vals of at least 5 seconds for a powerful

steam shot with preconditioning steam.

Precision Shot can be activated when dry

ironing. However, the temperature selector

has a minimum temperature level 3 (•••).

The Precision Shot function can also be

used in the vertical position for steaming

hanging clothes.

Caution: Hot steam comes out from the

preconditioning nozzles.

Spray function

Press the spray button (5).

Dry ironing

Set the steam regulator (6) on position «0»

(= steam off).

Automatic shut-off

The «auto-off» mechanism causes a slight

rattling noise during ironing. This is normal

and in no case indicates a fault of the iron.

The red «auto-off» light (9) will ﬂ ash when

the automatic shut-off is activated.

This happens when the iron has rested:

– horizontally on its sole plate for about

30 seconds or

– vertically on its heel rest for about

8 minutes.

To turn on the iron again, just move it.

When the «auto-off» pilot light stops

ﬂ ashing, the electrical power is on again.

The automatic shut-off will be activated

approximately 2 minutes after the iron is

plugged into a socket.

D Textile Protector

Before attaching the Textile Protector (10)

for the ﬁ rst time, iron approximately

2 minutes without Textile Protector. The

Braun Textile Protector protects delicate

fabrics from heat damage and makes it

possible to iron most dark fabrics without

an intermediate cloth.

A special coating avoids shiny patches.

However, in order not to damage the

coating, avoid ironing over e.g. zippers,

metal buttons/rivets or strass with the

Textile Protector attached.

To check the reaction of your fabrics

before you start ironing, we recommend

that you iron a small section of material on

the reverse side. With the Textile Protector

, you are able to iron delicate fabrics with

the temperature setting (•••) to «max», so

that you can use all steam functions your

iron offers.

After having attached the Textile Protector,

wait about 1 1/2 minutes before you start

ironing. Always store your iron with the

Textile Protector detached.

E After ironing

Unplug the iron and turn the steam

regulator to position «0». To prolong the

life of the iron, empty the water tank.

Store the cool iron in a dry place always

standing on its heel rest.

F Maintenance and cleaning

To clean the sole plate, use steel wool.

Never use a scouring pad, vinegar or

other chemicals.

G Cleaning the anticalc valve

The anticalc valve located on the lower

end of the steam regulator has to be

decalciﬁ ed regularly (e.g. whenever steam

development is insufﬁ cient). For this, the

water tank has to be empty.

Removing the steam regulator with the

anticalc valve

Turn the steam regulator clockwise

towards the steam setting «6». Keep

on turning ﬁ rmly beyond the resistance

until the steam regulator is lifted. When

positioned at x, pull it out vertically.

Do not touch the anticalc valve at its lower

end. Immerse the anticalc valve in vinegar

(not vinegar essence) or lemon juice for

5712710084_TS_745-715_S06-80.indd 105712710084_TS_745-715_S06-80.indd 10 18.11.13 08:2818.11.13 08:28

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Braun TS 725A Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info