517806
16
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
Seasonal maintenance is only
required if you have a cooler fitted
with a bleed system. The following
pages outline the maintenance
required at the end of the season and
then at the start of the next season.
This ensures that your cooler
continues to operate efficiently.
If your cooler is fitted with a drain
valve no seasonal maintenance is
required. However, we require that
the following components and the
operation thereof, be checked after
the first year, then every 2 years as
routine maintenance.
(1)...... Belt drive.
(2)...... Pump.
(3)...... Drain valve.
(4)...... Solenoid and associated
filter.
(5)...... Fan motor operation and
current.
(6)...... Float valve.
Routine maintenance may be
required more frequently in adverse
environmental situations and very
dusty areas.
Note
Failure to carry out regular
maintenance will affect your
warranty coverage.
!
WARNING
As your cooler is mounted on the
roof, we suggest that any
maintenance or checks be carried
out by an authorised Breezair
dealer or service agent. Climbing
onto the roof can be hazardous
and could result in injury to you
and damage to your property.
END OF SEASON
(1).. Turn off the water supply to
the cooler.
(2)...Remove the pad frames as
shown on page 17.
(3)...Turn off the power at the
isolating switch inside the
cooler.
(4)...Check and clean the water
distributing channels
under the lid.
(5)....Unclip and remove the
bleed system as shown
below. Take care not to
lose the o-ring. This
removal will allow the
water to drain from the
tank throughout the winter.
(6)....Thoroughly clean the tank
and the pump filter. Do
not replace the bleed
system. If you do, water
will sit without draining
from the tank throughout
the winter months.
(7).... Refit the pad frames.
HEALTH REGULATIONS
In some states, regulations require
that evaporative air coolers be
serviced at specific intervals.
1
ILL1141-A
2
1
®
16
Evaporative Cooler
PRE-SEASON
NOTE: Do
not wash the pads with
high pressure water spray.
WARNING:
Do not run the cooler with
the pad frames removed.
(1)...Turn your main switchboard
power off.
(2)...Remove the pad frames as
shown in the next column.
(3)...Ensure the power is off at
the isolating switch inside the
cooler.
(4)...Gently wash the pad frames
to remove any dust build up
during the winter.
If the pads are salted-up
replace them.
(5)...Replace the bleed system
that was removed at the end
of the last season. Ensure
that the o-ring is in place and
that the tray is positioned so
that it can catch the water
from the pad.
(6)...Turn on the water supply to
the cooler.
(7)...Check for water leaks.
Check operation of float
valve.
(8)...Check if adj. required to belt
drive. Reset motor amps.
(9)...Switch on the isolating
switch.
(10).Refit the pad frames.
(11).Turn the power on at your
main switchboard.
(12).Run the cooler.
REMOVING PAD FRAMES
To remove a pad frame:
(1)...Remove the clips holding the
pad frame in place.
(2)...Insert a flat head screw
driver into the slot between
the lid and the top of the pad
frame. Lever it so the pad
frame is released.
(3)...... Take hold of the pad frame,
pivot it outwards and lift it up. Be
careful not to damage the pad.
Repeat the steps above with the 3
remaining pad frames.
(For EXH210 units only) There are
90mm pads fitted to the front and rear,
with 100mm pads fitted to the sides
(facing the fan scroll holes). These
pads must be re fitted to their original
positions, or the larger pads could
catch on the float valve or components
mounted on the scroll.
The 100mm pads can be identified by
a rebate at the base of the Chillcel.
If fitted incorrectly, a drop in
performance may be found, water
can bypass the pad and be carried
over into the airstream and ducting
and/or damage to the pads or
electronic components may occur.
ILL950-C
1
2
3
ILL187-E
1
2
3
SEELEY INTERNATIONAL OWNER’S MANUAL 17
16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Breezair EX series wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info