Bedienungsanleitung Bresser 4701127 (Seite 5 von 40) (Englisch)

784607

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

-5-

IMPORTANT NOTE!

Beforeeachobservationyoushouldmakesurethatthetiltingmirrorisinthe"UP"position

(14,Fig.2).Forfurtherinformationpleaserefertochapter"Operatingthetiltingmirror"

on page 11.

Assembling the MCX Telescope

To operate the MCX, you need an additional eight AA batteries - the assembly takes place

in just four steps:

1.MounttheLEDviewfinderusingtheAllenkeyasshowninFig.8shownontelescope

tube.

IMPORTANT NOTE!

Make sure that the mirror surface of the LED viewfinder points towards the tube opening

when attaching it.

Formoreinformationontheorientationoftheviewfinder,refertochapter"Use-TheLED

Viewfinder".

2.InserttheSP26mmeyepiece(1,fig.2)intotheeyepiecesocket(4,fig.2).Tightenthe

clamping screw (3, fig. 2) to touch tightness (do not overtighten).

3.Thebatterycompartmentofthetelescope(6,fig.9)islocatedatthebottomofthe

basemotorhousing. Bring the telescope, as pictured in Fig. 9, into a secure lateral

position.Simultaneouslypressthetworetainingclips(4,fig.9)andopenthebattery

compartment.Liftthebatterycompartmentcover(5,fig.9)fromthebasehousing.

Nowinsert theeightAAbatteries intothebattery compartment,observingtheir+/-

orientation, which is indicated on the battery compartment base.

Alternatively,usetherecommendedpowersupplyunit(art.no.0455121).Connectitto

thefemale12Vjacksocketconnector(4,fig.10)foundonthesidepanel.

WARNING!

Insert the batteries with the great care! Do not insert the batteries upside down, do not mix

old and new batteries and only use batteries of the same type. Do not use rechargeable

batteries! If these precautions are not followed, or if batteries (even single ones and only

for a short time) are inserted the wrong way round, irreversible damage may occur to the

MCX itself, which is not covered by the telescope’s warranty! Further damage caused by

leaking, heating, possibly burning or bursting batteries, cannot be covered by the warranty

either!

4. Place the telescope upright on a table. Make sure that the power supply switch on the

sidepanel(1,fig.10)isintheOFFposition.Connectthecoiledcableofthehandheld

computertotheHBXsocket(3,fig.10).

The assembly of the MCX telescope is now complete. Now the assembly on the field

tripod follows.

Assembly

Fig. 8

Installation of the LED viewfinder

Bottom view of the MCX:

(1) Thread for the tripod; (2) Drive housing;

(3) Housing screws (!Only to be opened by

authorized service technician!); (4) Holding

clamps; (5) Battery compartment cover; (6)

Battery compartment

Interface field: (1) ON/OFF switch; (2)

accessory port*; (3) HBX connector for

handheld computer; (4) 12V connector; (5)

power supply indicator lamp

*not active on these models, as no suitable

accessories currently available

Fig. 9

Fig.Fig. 10 10

ce d

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bresser 4701127 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bresser 4701127

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info