632885
14
Zoom out
Zoom in
Vorherige Seite
1/44
Nächste Seite
14
USING TABLE STAND OR WALL
MOUNTING
The main unit has a removable table stand, which
- when connected - can support the unit on a flat
surface. It is possible to remove the stand and
mount the unit on a wall using the recessed screw
hole. The same applies to the remote unit; it can be
placed on a flat surface or mounted on a wall using
the recessed screw hole.
OPERATION
Receiving measurements and time signal
Once batteries are placed in the remote unit, it will
start transmitting temperature readings at roughly 45
second intervals. As soon as batteries are installed
in the main unit it will start searching for a signal
from the remote sensor for about 3 minutes. Upon
successful reception of the signal, the outdoor
temperature will be displayed on the main unit. The
main unit will automatically update its readings at
about 45 second intervals.
Subsequently, the main unit will attempt to receive
the DCF77 radio signal. The reception symbol
flashes. When the time signal is received after 3-5
minutes, the current time and date appear in the
display. The reception symbol will now be shown
permanently in the display. Date and time are
automatically updated daily at 2:05 o’clock (CET) by
the main unit.
Temperature and humidity
1. Press the DOWN button to switch the displayed
temperature between °C and °F.
2. Once the battery is installed, the main unit
will start displaying the interior measurement
information. The main unit will display the
information from the remote sensor for the first
time approximately 3 minutes after the power
supply was established.
3. There are 3 different icons to displaying the
indoor climate as below:
humidity is same or lower than 40%
humidity is same or higher than 70%
humidity is higher than 40% but lower than 70%;
at same time, the temperature is higher than 20°C
(68°F), but lower than 27°C (80.6°F)
Max/Min records of temperature and humidity
1. Pressing and releasing the UP button in short
intervals repeatedly makes the display alternate
between the current temperature and humidity
as well as MIN/MAX recordings.
2. In MIN/MAX temperature display mode, hold UP
button to reset all indoor and outdoor MIN/MAX
records to current values.
4. The MIN/MAX temperature and humidity values
will be recorded automatically.
3. The MIN/MAX temperature and humidity records
automatically will be reset at 0:00 o’clock (12:00
a.m.) every day.
Current weather and weather trend
The weather forecast is depending on the
fluctuation of temperature and humidity. From
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

bresser-70-00001-temeotrend-sunny

Suche zurücksetzen

  • Bei minus Temperaturen zeigt mein Gerät plus 10,2 bis 10,7 Grad an. Batterien alle ok. Eingereicht am 26-12-2020 10:42

    Antworten Frage melden
  • Meine Temperatur Anzeige zeigt immer nur HH.H an . Der Sender auch . Ich habe schon neue Batterien eingelegt, ohne Erfolg. Was ist zu tun ? Eingereicht am 17-8-2020 17:34

    Antworten Frage melden
  • suche BA 10577AO
    M E170968 WZ - 2 G47A1
    Ersatzteil Wetterstation von BRESSER aRT: Nr. 70-00001 Eingereicht am 23-9-2019 19:48

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bresser 70-00001 TemeoTrend Sunny wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info