729974
15
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
15
NOTE!
When maximum or minimum reading is displayed, the corresponding
timestamp will be shown.
HI / LO ALERT
HI/LO alert are used to alert you of certain weather conditions. Once
activated, the alarm will turn on and amber LED starts flashing when
a certain criterion is met. The following are areas and type of alert
provided:
Bereich Verfügbarer Alarm-Typ
Indoor temperature HI AL / LO AL
Indoor humidity HI AL / LO AL
Outdoor temperaturw HI AL / LO AL
Outdoor humidity HI AL / LO AL
Rainfall HI AL*
Wind speed HI AL
*Daily rainfall since midnight
HI / LO alert setting (Fig. 29)
1. Press
button several times until the desired area is selected.
2. Use
or buttons to adjust the setting.
3. Press
button to confirm and continue to next setting.
Fig. 29
Enable/Disable HI / LO alert (Fig. 30)
1. Press
button several times until the desired area is selected..
2. Press
button to turn the alert on or off.
3. Press
button again to confirm and continue to next setting.
Fig. 30
NOTE!
1. The unit will automatically exit setting mode in 5 seconds if no
button is pressed.
2. When ALERT alarm is on, the area and type of alarm that triggered
the alarm will be flashing and the alarm will sound for 2 minutes.
3. Press SNOOZE/LIGHT button when alarm sounds to interrupt the
alarm. The alarm will then start again after 5 minutes.
4. Press
button when alarm sounds to deactivate the alarm until
next time.
The alarm automatically turns off after 2 minutes.
WIRELESS SIGNAL RECEPTION
Fig. 31
No sensor Signal searching Strong signal Weak signal Signal lost
The 5-in-1 sensor is capable of transmitting data wirelessly over an
approximate operating of 150m range (line of sight).
Occasionally, due to intermittent physical obstructions or other
environmental interference, the signal may be weaken or lost.
In the case that the sensor signal is lost completely, you will need to
relocate the main unit or the wireless 5-in-1 sensor.
POINTING 5-IN-1 SENSOR TO THE SOUTH
The outdoor 5-in-1 sensor is calibrated to be pointing to North
by default. However, in some cases, users may wish to install the
product with the arrow pointing towards the South, especially
for people living in the Southern hemisphere (e.g. Australia, New
Zealand).
1. First install the outdoor 5-in-1 sensor with its arrow pointing to the
South. (Please refer to 'Installation' chapter for mounting details)
2. Press and hold
button for 8 seconds until the upper part
(Northern hemisphere) of the compass rose is blinking.
3. Use
or button to change to lower part (Southern
hemisphere).
Fig. 32
Northern hemisphere Southern hemisphere
4. Press button again to confirm and exit.
DISPLAY COLOUR CHANGE
1. Press [ LOOP ] key to activate the automatic colour change.
Display changes continuously between 256 colours.
2. Press [ LOOP ] key again to disable colour change function. Press
[ RAINBOW ] key several times to select a colour from the
following and display it permanently: white > red > orange > yellow
> green > light-blue > deep blue > purple
3. Press [ LOOP ] key again to disable colour change function.
Press [ OUTDOOR TEMP ] key to run display colour change
depending on the outdoor temperature. The display colour
changes regarding to the values in the table below:
Temperature range Colour Temperature range Colour
under -20.0° C darkblue 16.1° to 20.0° C orange 2
-19.9° to -11.0° C lightblue 1 20.1° to 24.0° C orange 3
-10.9° to -5.0° C lightblue 2 24.1° to 28.0° C red 1
-4.9° to -2.0° C lightblue 3 28.1° to 32.0° C red 2
-1.9° to 1.0° C white 32.1° to 36.0° C pink 1
1.1° to 4.0° C lightgreen 1 36.1° to 40.0° C pink 2
4.1° to 8.0° C lightgreen 2 40.1° to 45.0° C purple
8.1° to 12.0° C yellow above 45.1° C gray
12.1° to 16.0° C orange 1
TROUBLESHOOTING
Problem/Symptom Solution
Strange or no measurement
of rain sensor
1. Check drain hole in the rain collector. Clean it
if neccessary.
2. Check the circular level. Realign the device if
neccessary.
Strange or no measurement
of Thermo/Hygro Sensor
1. Check radiation shield. Clean it if neccessary.
2. Check sensor housing. Clean it if neccessary
and --- (no signal for
15 minutes)
1. Relocate main unit and 5-in-1 sensor closer to
each other.
2. Make sure the main unit is placed away from
other electronic appliances that may interfere
with the wireless communication (TV‘s,
computers, microwaves).
3. If problem continues reset both, main unit and
5-in-1 sensor.
and ER (no Signal for
1 hour)
15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

bresser-7002520-weather-center-5-in-1-colour

Suche zurücksetzen

  • Wie kann man die Sprache an der Wetterstation einstellen
    Eingereicht am 2-7-2022 16:48

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bresser 7002520 Weather Center 5-in-1 Colour wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Bresser 7002520 Weather Center 5-in-1 Colour

Bresser 7002520 Weather Center 5-in-1 Colour Bedienungsanleitung - Französisch - 12 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info