637967
10
Zoom out
Zoom in
Vorherige Seite
1/36
Nächste Seite
10
REGULAR MAINTENANCE
The following components should be inspected and cleaned
(as necessary) before every usage of your gas grill to ensure
optimal performance, safety and efficiency.
STAINLESS STEEL COOKING GRIDS
Brush grids with a long-handled stainless steel grill brush to
remove loose debris. Next, perform a Burn-Off (see below).
After the Burn-Off and while grill is still hot, brush the grids
again to remove any remaining debris. As the grill is hot, use
caution and oven mitts while handling the brush.
CAST IRON COOKING GRIDS
All OMC cast iron cooking grids are coated with a durable
porcelain enamel finish to protect the grids and reduce the
tendency of food sticking to grids. With all OMC cast iron
cooking grids instead of burning off your grill after each usage,
we recommend leaving food residue on grids and performing
a Burn-Off (see below) before each use; this helps build up a
protective layer of oil on the grids and will aid in preventing rust
and deterioration.
Cast iron grids should be seasoned before every use by wiping
or spraying them with vegetable or olive oil. Ensure that the
whole surface of the grid is covered by a light layer of oil. This
helps prevent rusting and deterioration. If rusting does occur,
scrape it off gently with a scrub pad and season thoroughly.
During longer periods of inactivity, grids should be seasoned,
wiped dry then stored in a dry place. Before first usage and
after periods of storage, grids should be washed (see “Cooking
Grids” to right), dried with paper towel then wiped down
thoroughly with vegetable shortening or olive/vegetable oil.
FLAV-R-WAVE
If residue accumulates on the Flav-R-Wave, remove the
cooking grids and scrape the residue off the Flav-R-Wave with
a grill brush.
GREASE TRAY
The grease tray is located directly under the drainage hole on
the bottom of the gas grill. It is accessible from the side or rear
of the appliance and should be cleaned or replaced regularly
to avoid grease overflowing onto your patio.
GENERAL CLEANING
Perform a Burn-Off (see below). When gas grill is cool, remove
grids, scrape the Flav-R-Wave clean then remove it. Clean the
interior of the gas grill as necessary by scraping the sides and
bottom of the cookbox and vacuuming.
BURN-OFF
Ignite the burners as per “Lighting” (page 6). Operate gas grill
on HIGH with lid closed for 10 min. or until smoking stops. Turn
the gas source off then turn control knobs to OFF.
ANNUAL MAINTENANCE
The following components should be inspected and cleaned at
least once a year or after any period of storage over 30 days to
ensure optimal performance, safety and efficiency.
BURNER
Remove burner and inspect for cracks and deterioration. Clean
venturi tubes using a pipe cleaner or venturi brush to eliminate
any blockages. See “Venturi Tubes.” (page 5) While the burner
is removed, clean the interior of cookbox by scraping the sides
and bottom of the cookbox and vacuuming.
HOSE
Inspect and replace if necessary. For propane see “Hose and
Regulator.” (page 4)
EXTERIOR FINISH
If white oxidation spots appear, wash the outside of the cookbox
with a mild soap and water solution. Rinse the surfaces
thoroughly then wipe them with a cloth dipped in cooking oil
to restore the luster. For repair of paint scratches and scuffs,
use a good quality HIGH temperature (600°F) spray paint
for touch-up. Rusting is a natural oxidation process and may
appear on cast-iron and steel parts. Rust will not affect short
term performance of your grill.
STAINLESS STEEL
Wash with soap and water. Use stainless steel cleaner to
polish and remove stains or marks. Weathering and extreme
heat can cause a stainless steel lid to turn a tan color. This
is discoloration and is not considered a manufacturing defect.
RESIN COMPONENTS AND SIDE SHELVES
Wash with soap and water.
REPLACEMENT PARTS
If a problem is found with the regulator, hose, burner, or control
valves, do not attempt repair. See your dealer, approved
service center, or contact the factory for repairs or replacement
parts. To ensure optimum performance, use only original OMC
replacement parts.
LEAK TEST
When reconnecting a gas cylinder on propane models, be sure
to check for leaks. See “Leak Testing.” (page 5)
COOKING GRIDS
To wash stainless or cast iron grids, use a light detergent
and water and then rinse and dry with paper towel; never air
dry grids or use a dishwasher. For cast iron grids, thoroughly
season (see left: “Cast Iron Cooking Grids”) after washing.
MAINTENANCE
10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

broilking-baron-590

Suche zurücksetzen

  • Hallo für was benötigt man die Kette mit dem Draht auf der Linken Aussenseite am Grill
    Eingereicht am 2-5-2020 07:37

    Antworten Frage melden
  • Ich hätte gerne das Handbuch, Bedienungsanleitung des Broiler King Baron 590 auf deutsch Eingereicht am 19-5-2019 00:05

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für BroilKing Baron 590 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von BroilKing Baron 590

BroilKing Baron 590 Installationsanweisung - Englisch, Französisch, Spanisch - 23 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info