Bedienungsanleitung Brother HL-2070N (Seite 73 von 109) (Englisch)

1869

Zoom out

Zoom in

Vorherige Seite

1/109

Nächste Seite

Troubleshooting

6 - 2

Error messages in the Status Monitor

The Status Monitor will report problems with the printer. Take the corrective actions listed in the following

table for the error message that the Status Monitor reports.

The default setting for the Status Monitor is off. If you would like to turn the status monitor on, you can change

the setting of the Status Monitor in the Device Options of the Advanced tab. See Device Options on page

2-6.

Error message Action

Cover is open ■Close the front cover of the printer.

Back Cover is open ■Close the back cover of the printer.

Memory Full ■Press the Go button to print the data remaining in the printer. Cancel the print

job if you want to delete the data remaining in the printer, see Cancel printing on

page 3-7.

■Reduce the print resolution or reduce the complexity of your document.

Print Overrun ■Press the Go button to print the data left in the printer. Cancel the print job if you

want to delete the data remaining in the printer, see Cancel printing on page 3-7.

■If this does not clear the error, reduce the complexity of your document or reduce

the print resolution.

■Set page protection to AUTO by using the supplied Windows® driver or Remote

Printer Console program.

■Change the following settings in the supplied Windows® driver and try again. The

best combination of these settings will vary depending on your document:

• Graphics mode

•TrueType

mode

• Use Printer TrueType® Fonts

No Paper Fed Tray 1

No Paper Fed Manual slot

■The paper tray may be out of paper or not properly installed. If it is empty, put a

new stack of paper in the paper tray and then press the Go button.

■If there is paper in the paper tray, make sure it is straight. If the paper is curled,

straighten it before printing. Sometimes it is helpful to remove the paper, turn the

stack over and put it back in the paper tray.

■Reduce the amount of paper in the paper tray, and then try again.

■Make sure you use paper that meets Brother’s recommended paper

specifications. See What kind of paper can I use? on page 1-4.

Paper Jam Tray 1

Paper Jam Inside

Paper Jam Rear

■Take out the jammed paper from the indicated area.

See Paper jams and how to clear them on page 6-5.

Toner Life End ■See Replacing the toner cartridge on page 5-3.

Toner Low ■Purchase a new toner cartridge and have it ready for when the Toner Life End

status is indicated.

Cartridge Position Error ■Take out the toner cartridge and put it back into the printer again.

Drum Life End Soon ■The drum is near the end of it's life. Purchase a new drum unit to replace the

current one. See Replacing the drum unit on page 5-8.

Drum Error ■See Cleaning the corona wire on page 5-14.

Service Call ■Check the LED indication to identify the error. See Service call indications on

page 3-5.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Brother HL-2070N Seite 73

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Brother HL-2070N

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info